Инструкция по эксплуатации Vitek VT-3497 — страница 7

CONNECTING THE SPEAKERS

1.To connect the speaker wires press the Right speaker jack (23) and Left speaker jack (22) levers. 2.Make sure that the speaker wires are connected to the speaker jacks observing polarity.

Connect the left speaker to the L jack and the right speaker to the R jack.

CONNECTING THE HEADPHONES

You can use headphones (not included in the set) Insert a 3.5 mm plug in the HEADPHONE jack (17). Use an adapter if the plug of your headphones is a different size When connecting headphones the speakers automatically disconnect Safety precautions To protect your hearing follow these recommendations.

- Adjust the volume before listening After you begin to listen adjust them to a comfortable level.

- Do not listen through the headphones at very high volume This can lead to hearing loss.

THE MAIN CONNECTIONS

This system is intended to be used at a voltage of 230 V 50 Hz Connecting this system to a grid with a different voltage can lead to breakage and annul the warranty If the plug of the power source does not fit the outlet in your home have a qualified electrician replace the outlet.

CONNECTING THE SYSTEM TO A POWER OUTLET

pletely extend the Power cord (24). 2.Insert the plug of the power cord into the nearest outlet. 3.As soon as you plug the system into a power outlet its components are in standby mode.

To disconnect the system completely pull the power cord from the outlet.

DIGITAL CLOCK AND TIMER

INSTALLING THE DIGITAL CLOCK

Insert the plug of the (24) Power cord into a power outlet The symbol will appear on the LCD

display (19). 1.Press and hold the MEMORY (13) PROGRAM (45) button for about 2 seconds to set the time display format.

2.Press the

SEARCH (7) (37) or

SEARCH + (8) (38) button to select the desired time display format.

3.Press the MEMORY (13) PROGRAM (45) button to save the selection.

The LCD display (19) will show two flashing symbols for setting the hour of the current time.

4.Press the

SEARCH (7) (37) or

SEARCH + (8) (38) buttons to set the hour of the current time. 5.Press the MEMORY (13) PROGRAM (45) button to save the set hour.

The LCD display (19) will show two flashing symbols for setting the minutes of the current time.

6.Press the

SEARCH (7) (37) or

SEARCH + (8) (38) buttons to set the minutes of the current time.

7.Press the MEMORY (13) PROGRAM (45) button to save the set minutes and immediately activate the digital clock Note: The time-setting mode will stop if the MEMORY (13) PROGRAM (45) button is not pressed within 10 seconds.

After pressing the STANDBY MODE (2)

(36) button to turn off the system the clock continues to work.

SETTING THE TIMER

1.Press the STANDBY MODE (2)/

(36) button to turn on the system.

ENGLISH