Инструкция по эксплуатации Vitek VT-3490 — страница 7

BATTERY INSTALLATION

1 Open the battery compartment cover to remove it. 2 Insert two "AAA"-size battery (not included) observing correct polarity according to diagram shown inside the battery compartment.

Note:

- About half a year of normal operation can be expected when using generic batteries.

- When batteries are exhausted the remote control unit should no longer operate the system Replace both batteries with new ones.

• When remote control unit is not to be used for a long time remove batteries to avoid damage caused by battery leakage and corrosion.

• Avoid keeping the remote control unit in extremely hot or humid locations.

- Between remote controller and remote sensor located on front cover of the unit there should be no obstacles and have to within 30° angle.

• The remote control's operating distance is about 0.2 M to 6 M away from the remote sensor.

BASIC FUNCTION

Volume Control

Rotate VOLUME Knob on the unit clockwise to increase or counterclockwise to decrease volume of sound.

To switch off the volume temporarily

Press MUTE button on the remote control and playback will continue without sound To restore volume press MUTE button on the remote control again or adjust the volume.

EQ CONTROL

When you press the EQ button sound tones will change to one of the following patterns: POP JAZZ CLASSIC or ROCK.

BBS CONTROL

When you press the BBS button on the remote control unit boost of bass tone will appear.

Power On/off operation

Press POWER button on the unit or POWER button onthe remote control to switch the system on/off.

RADIO/CASSETTE/CD/MP3 OPERATION

USING THE RADIO

1 Press FUNC button to select TUNER mode. 2 Press BAND button to select the desired radio band: AM or FM 3 Tune to desired radio station by press BACK/TUNE DOWN or NEXT TUNEUP

Manual Tuning: Press BACK/TUNE DOWN or NEXT TUNEUP and then release it within1 sec Auto Tuning: Hold BACK/TUNE DOWN or NEXT TUNEUP for over 1 sec then release it at any time After key is released auto-tuning operation will start until it finds a station Preset Channel: (Program up to 10 favorite frequency on each band)

(1) Press BACK/TUNE DOWN or NEXT TUNEUP to select desired station. (2) Press MEMORY button once the MEMORY number indicator will appear on the display. (3) Press PRESET-UP OR PRESET DOWN button to select the desired number under which you wish to store the station

(4) Press MEMORYbutton to save the station. (5) Repeat steps 2 to 4 of the procedures to other stations. 4 After end of programming procedure press PRESET-UP or PRESET-DN buttons to begin listening to stations you programmed into memory.

5 Adjust VOL UP/VOL DOWN to desired volume level. 6 Extend TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting When listening to AM broadcasting gently rock the unit back and forth to get the best reception or place the unit in another location.

ENGLISH

3490.qxd 24.01.2005 18:27 Page 6