Инструкция по эксплуатации Vitek VT-3468 — страница 5

ENGLISH

REMOTE CONTROL

POWER SOURCE (SYSTEM WITH 2 POWER SOURCES)

This appliance is designed to be used from two different power sources which are listed below:

DC POWER SOURCE

This appliance can be powered by 8 type UM2 or C batteries For best results always use alkaline batteries.

INSTALLING THE BATTERIES

1 Remove the battery compartment lid by gently pressing on it and pulling it up Insert 8 type UM2 or C batteries MAKE SURE TO OBSERVE POLARITY (+ ) AS INDICATED ON THE INSIDE OF THE COMPARTMENT. 2 Close the lid.

NOTE: To avoid damage to your appliance remove the batteries if the appliance will not be used for a long time or if the batteries have gone dead

NOTE: If you wish to power the appliance with batteries unplug the power cord both from the power outlet and from the rear panel of the appliance.

AC POWER SOURCE

Insert one end of the power cord into power cord jack (33) and the other end into AC outlet.

NOTE: If your appliance is equipped with AC input voltage selector switch make sure that it is set on voltage the same as voltage in you local area.

38.On/Off button 39.Mute button 40.PBC button 41.P/N button 42 OSD button 43 REPEAT A-B button 44 REPEAT 1 ALL button 45 PROGRAM button 46.ZOOM button 47 STEP button 48 VOLUME DOWN button 49.PLAY/PAUSE button 50.PREV button 51.Battery compartment lid 52 MODE button 53 Tone down button 54 Tone restore button 55 Tone up button 56.TIME button 57 RETURN/STOP button 58 NEXT button 59.VOLUME UP button 60.SLOW button 61.SOUND button 62.AUDIO button 63.Numeric buttons