Инструкция по эксплуатации Vitek VT-1011 — страница 9

larly: China TV > USA TV > USA CATV > Europe TV > Germany CATV > France CATV > Italy CATV >
Russian CATV > England CATV > Australia CATV. Note: The unit is set up according to local television network before leaving factory. 4 When AUTO PROGRAM is selected press VOL+ key to enable auto scan for channels Green Channel No.s will be displayed on screen When one channel is found and saved the green Channel No will turn red.

EXTRA FUNCTIONS Under TV or AV mode select EXTRA in menu by pressing CH+ or CH key Press VOL+ or VOL key to enter submenu Then press CH+ or CH key to select as follows:

CC > BLUE BACK

1 Closed Caption Display ( CCD ) mode function is only available in USA This function is not applicable for other countries. 2 When submenu BLUE BACK is selected press VOL+ and VOL key to select BLUE BACK ON or BLUE BACK OFF. 3 When BLUE BACK ON is selected screen will turn blue and be muted while there is no TV or AV signal input If there is TV or AV signal input unit will display picture automatically Under TV status when blue back is on screen for 10 minutes unit will enter stand by mode.

OTHER FUNCTIONS

1 Picture Display Mode Selection Press Picture Key on the remote control to select SOFT,PERSONAL or DYNAMIC 3 different picture dis play mode.

2 Sleep Timer Setting Pressing Sleep key on remote control can preset the TV OFF time After certain period of time TV will turn off automatically and enter Power Stand by mode. 1 When you press SLEEP key once the screen will display the remainder time from now to sleep. 2 When you press SLEEP key again the screen will display the sleep time to be set: TIMER 30 Every time pressing SLEEP key will add 30 minute But the maximum is 180 minutes After 180 minutes it will back to 0 minute See below 0Min > 30Mins > 60Mins > 90Mins > 120Mins > 150Mins > 180Mins

3 When there is only 5 minutes left from now to sleep time the remainder time will be on screen every 1 minutes and last for 5 seconds. 4 When there is only 3 seconds left from now to sleep time the remainder time will be displayed on screen in red until unit is turned off and enters Power Stand by mode. 5 Pressing Power key will cancel the Sleep Timer Setting. 6 Pressing Sleep key on remote will change the Sleep Timer setting

ON SCREEN DISPLAY There are two mode of DISPLAY key one is ON the other one is OFF It will display present TV mode about following :
1 Channel No. 2 TV NETWORK NAME 3 PROGRAM TITLE 4 CLOCK 5 SLEEP TIMER 6 COLOR SYSTEM 7 SOUND SYSTEM

ENGLISH

РАСПОЛОЖЕНИЕ ОРГАНОВ УПРАВЛЕНИЯ (ПЕРЕДНЯЯ И ЗАДНЯЯ ПАНЕЛИ)

РУССКИЙ

VT-1011.qxd 30.10.03 14:48 Page 18