Инструкция по эксплуатации TIMBERK TAP FL300 MF — страница 12

Turning on and offthe device

Connect theequipment into an outietCiick on-off unit air cieanerwiil work

Press the button again the device turns off.

Sensor mode

Ciick Sensor after 3 minutes the sensor wiii determine the quaiity of air up to this point indicator of air quaiity (Fig 1 item 1) can giow red After 3 minutes if the indoor air ciean and cióse to the net the LED wiii giow biue when the air is very dirty-the LED wiii giow red ifthe air is poiiuted but not much-the LEDwiiigiowpurpie.

When the sensor mode other modes which are controlied by pressing the

Mode wiii network.

in the sensor unit automaticaiiy adjusts the fan speed and consequentiy the performance of air cieaning ifthe air is ciean (biue LED) the unit shuts down or wiii be run at iow fan speed if air poiiution is not much (vioiet iight) the unit wiii operate with iow or medium fan speed ifthe air is heaviiy poiiuted (red) the device wiii operate at high fan speed.

Ciick Sensor again to exit this mode.

The user can adjust the sensitivity of the sensor in air quaiity The button adjustment of sensor sensitivity (Low High) is behind the front panei (see Fig 7).

Fig.7

Кнопка регулировки чувствительности сенсора (Low-High)

ifthe button adjustment of sensor sensitivity is set to Low iow sensitivity of the sensor ifthe sensor sensitivity adjustment button is set to High High sensitivity of the sensor From this setting may depend on the intensity of the device and coior dispiay mode air quality sensor Sensor.

ATTENTION!

Air quality sensor has an internal memory so the sensitivity is not always able to change immediately after the switch button Low-High To quickly activate the newly defined set of sensor sensitivity unplug from the wall outlet then plug in again Sensitivity of the sensor will change.

Cleaning the sensor

Fig 8

I' ^

Air quality sensor should be cleaned 1 time in two months.Todo this opena window on the side of the sensor device (Fig 8).

Clean with a damp cloth then wipe the sensor must dry cloth.

Color Mode setting

With the mode button MODE (Fig 2 item 3) Select the manual installation (Fig 3 Section 21) lights up the appropriate indicator In this mode the unit will run continuously until it is turned off by the user.

Automatic mode AUTO

With the mode button MODE (Fig 2 item 3) to select automatic operation lights up the corresponding LED (Figure 3 paragraph 20) In this mode the device will work for 20 minutes and then stops for 40 minutes The cycle is repeated To exit this mode you must select another mode with the same button.

12 • air purifier