Инструкция по эксплуатации Thomas Twin Aquatherm — страница 17

4.1 Information and precautionary measures for use

¼ Do not use the TWIN AQUATHERM for dry vacuuming if the AQUAFILTER system has not been fitted in accordance with the instructions booklet Otherwise the appliance may get damaged.

¼ Do not vacuum liquids in dry vacuum mode Read section 5.3 “Wet vacuuming operation”.

¼ Read the “Points of safety” under section 1 2.

¼ Do not vacuum great quantities of fine dust e.g flour cocoa powder cement.

4.2 Dry vacuuming operation

If the appliance has been used before for wet/wash vacuuming all the instructions in this section must be followed Your TWIN AQUATHERM is set up ex works for dry vacuuming – in this case read from point k

onwards.

Open the casing cover (1) by lifting the cover release (4).

Remove the dirty-water container assy (24) by its carrying strap and if necessary extract the inserted anti-slosh insert (22).

Insert the HEPA filter (20) into the appliance.

D Insert the AQUA filter assy (42) behind both guide ledges of the dirty-water container (24) until it stops Ensure that the seal around the AQUA filter (42) is on the inside of the dirty-water container (24) and that the wet filter (23) has been fitted.

Fill the dirty-water tank (24) with 1 litre of clear water.

Insert the filled dirty-water container (24) into the appliance and fold the carrying strap to the side.

Ensure that the carrying strap is not covering the casing seal.

Slowly close the casing cover (1) so that the seals and the connectors on the AQUA filter (42) are not damaged.

Attach accessories as required to the suction pipe (34) or directly to the handle (29)

Connect the mains plug (63).

Switch on the appliance using the appliance on/off switch (14).

The suction power can be reduced using the suction power regulator (supplementary air slide) (29).

Suppl air slide closed = full suction power suppl air slide open = reduced suction power.

On carpet floors a half-open supplementary air slide will achieve the best water filter action and prevent the nozzle from becoming blocked.

To achieve optimum filter action we recommend that you rinse the AQUA filter with clear water and change the water in the dirtywater container every 40-60 minutes of continuous operation or whenever you see a large pool of water on the underside of the cover.

After dry vacuuming

For reasons of hygiene empty and clean the AQUAFILTER system after each use Dirty water and moisture on the appliance parts encourage bacteria and fungi to multiply Switch off the appliance using the main switch (14) and pull out the mains plug.

Open the casing cover (1) by lifting the cover release (4).

Remove the dirty-water container (24) from the appliance by its carrying strap.

Remove the AQUA filter (42) from the dirty-water container (24) by its handle and pour away the dirty water (e.g down the toilet).

Remove the foam filter (43) To do this gently pull the frame (48) on the AQUA filter (42) upwards and fold it away to the side.

Clean the wet filter (23) if it is dirty.

Thoroughly wash the AQUA filter (42) the foam filter (43) the wet filter (23) and the dirty-water container (24) with clear water without any cleaning agent Ensure that the parts are completely dry before replacing them in the appliance If impurities and fluff have clogged the suction filter (44 illus E) this can also be removed for gentle cleaning; afterwards replace the suction filter in the appliance Remove impurities and fluff from the AQUA injection nozzle (10 illus H).

Cleaning the HEPA filter

Your TWIN AQUATHERM has a high-quality HEPA filter which can be cleaned frequently as required and according to the type of household dirt This will ensure that the appliance regains full suction power Cleaning should be carried out depending on the level of usage and the reduction in suction power (at least every 6 months).

Remove the HEPA filter (20) from the appliance and knock it on a firm surface

If the dirt cannot be removed in this way the filter can also be washed with clear water without any cleaning agent and then knocked on a firm surface.

Never use a brush for cleaning Ensure that the filter is completely dry before replacing it in the appliance.

When cleaning the HEPA filter (20) do not damage the filter wires If the suction power of the appliance is not considerably increased by cleaning the HEPA filter the filter should be replaced with a new one.

4.0 Dust vacuuming (dry vacuuming)

5.0 Spray extraction (wash-vacuuming)/wet vacuuming of hard surfaces tiles carpets and upholstery

5.1 Information and safety instructions for use

Make sure that all items to which you are going to apply a hot or cold detergent solution are suitable for this method of cleaning.

Do not use the cleaner on parquet floors Moisture could penetrate the wood and damage the floor.

Caution!

Petrol thinner fuel oil etc may form explosive fumes or mixtures if allowed to mix with the suction air flow.

Acetones acids and solvents may attack the materials employed on your appliance It is quite safe to vacuum water which contains ordinary household cleaning agents

After wet vacuuming or spray extraction operations clean the soiled-water tank and all employed accessories and allow to dry.