Инструкция по эксплуатации Sulky Seed Master — страница 6

the engine and re-move the key from the ignition. 5 If the primary universal drive shaft is fitted with a torque limiter or a free wheel these must be mounted on the machine power take-off. 6 Always ensure that universal drive shafts are fitted and locked correctly. 7 Always ensure that universal drive shaft guards are immobilized in rotation using the specially provided chains. 8 Before engaging power take-off ensure that the speed selected and the direction of rotation of the power take-off comply with the manufacturer’s instructions. 9 Before engaging power take-off ensure that no persons or animals are close to the machine. 10 Disengage power take-off when the universal drive shaft angle limits laid down by the manufacturer are in danger of being exceeded. 11 Caution! When power take-off has been disengaged moving parts may continue to rotate for a few moments Do not approach until they have reached a complete standstill. 12 On removal from the machine rest the universal drive shafts on the specially provided supports. 13 After disconnecting the universal drive shafts from the power take-off the protective cap should be fitted to the power take-off. 14 Damaged power take-off and universal drive shaft guards must be replaced immediately.

HYDRAULIC CIRCUIT

1 Caution! The hydraulic circuit is pressurized. 2 When fitting hydraulic motors or cylinders ensure that the circuits are connected correctly in accordance with the manufacturer’s guidelines. 3 Before fitting a hose to the tractor’s hydraulic circuit ensure that the tractor-side and machineside circuits are not pressurized. 4 The user of the machine is strongly recommended to identify the hydraulic couplings between the tractor and the machine in order to avoid wrong connection Caution! There is a danger of reversing the functions (for example:
raise/lower). 5 Check hydraulic hoses once a year:
Damage to the outer surface Porosity of the outer surface Deformation with and without pressure State of the fittings and seals The maximum working life for hoses is 6 years When replacing them ensure that only hoses with the specifications and grade recommended by the machine manufacturer are used. 6 When a leak is found all necessary precautions should be taken to avoid accidents. 7 Pressurized liquid particularly hydraulic circuit oil may cause serious injury if it comes into contact with the skin If the case of injury consult a doctor immediately There is a risk of infection. 8 Before any operation on the hydraulic circuit lower the machine release the pressure from the circuit turn off the engine and remove the key from the ignition.

MAINTENANCE

1 Before commencing any maintenance servicing or repair work or before attempting to locate the source of a breakdown or fault it is essential that the power take-off is disengaged the engine turned off and the key removed from the ignition. 2 Check regularly that nuts and screws are not loose Tighten if necessary. 3 Before carrying out maintenance work on a raised machine prop it up using appropriate means of support. 4 When replacing a working part (fertilizer spreader blade or seed drill coulter) wear protective gloves and only use appropriate tools. 5 To protect the environment it is forbidden to throw away oil grease or filters of any kind Give them to specialist recycling firms. 6 Before operating on the electric circuit disconnect the power source. 7 Protective devices likely to be exposed to wear and tear should be checked regularly Replace them immediately if they are damaged. 8 Spare parts should comply with the standards and specifications laid down by the manufacturer Only use Sulky spare parts. 9 Repairs affecting parts under stress or pressure (springs pressure accumulators etc.)
should be carried out by suitably qualified engineers with special tools.

DANGER

Wings

Chains and meter wheel

Do not stay on the walkway while working

Fill auger

Openers