Инструкция по эксплуатации Sony PlayStation 3 — страница 7

Precautions

Be fo re us e

• Use only an Ethernet cable compatible with 10BASE-T 100BASE-TX or 1000BASE-T networks Do not use a cord for a standard residential telephone line or cables of types other than those mentioned here Using the wrong type of cord or cable can cause more electrical current than necessary to flow through the LAN connector which may lead to heat build-up fire or malfunction.

• The 2.4 GHz range of radio waves used by the wireless networking feature of this product is a range shared by various devices This product has been designed to minimise the effect of other devices using the same range However in some cases interference from other devices may reduce the connection speed shorten the signal range or cause the connection to be terminated unexpectedly.

• When using the PS3™ system's scan function to select a wireless LAN access point access points that are not intended for public use may be displayed Only connect to an access point that you are authorised to use or one that is available through a public wireless LAN or hotspot service (Models equipped with the WLAN feature only)

If the system or disc is brought directly from a cold location to a warm one moisture may condense on the lens inside the system or on the disc Should this occur the system may not operate properly In this case remove the disc and turn off and unplug the system Do not put the disc back in until the moisture evaporates (this may take several hours) If the system still does not operate properly contact the appropriate PlayStation

customer service helpline which can be found within every

PlayStation

PlayStation

2 and PLAYSTATION

3 software manual.

For safety reasons before cleaning the system or connected accessories disconnect the AC power cord from the electrical outlet.

Exterior surfaces (plastic cover of system and Wireless Controller)

Follow the instructions below to help prevent the product exterior from deteriorating or becoming discoloured.

- Wipe with a soft dry cloth.

- Do not apply insecticides or other volatile substances.

- Do not place any rubber or vinyl materials on the product exterior for an extended period of time.

• Do not use solvents or other chemicals Do not wipe with a chemically-treated cleaning cloth.

Vents

When dust accumulates in the system vents remove the dust with a low-powered vacuum cleaner.

Connectors

Do not use when the connectors of the system or the AC power cord are not clean If used when dirty the flow of electrical current may be obstructed Remove the dirt with a dry cloth.

Wireless networking feature

Moisture condensation

Cleaning

Backing up data

You should where possible make periodic back-ups of data stored on the hard disk drive as a precaution against possible loss or corruption If for any reason software or data loss or corruption occurs it is not possible to restore or repair the software or data Note that SCEE will not be liable for any loss or corruption of data files or software.