Инструкция по эксплуатации Saturn ST-VC7294 — страница 3

8.Turn off the control before unplugging

9.Do not use the machine for vacuuming any type of chemicals acids or solvents This will damage the machine.

10 Do not use the product near explosive materials inflammable liquids or any type of gas Such usage can cause fire or explosions.

11 Do not use for any purpose other than described in this user’s guide.

12 Using improper voltage may result in damage to the motor and possible injury to the user correct voltage is listed on the rating label.

13 Do not disconnect the AC plug from the main outlet roughly Never remove the

AC plug by pulling the cord; always pull out the plug by holding the plug itself.

14 Do not connect or disconnect the AC plug from the main outlet with wet hands This may result in an electrical shock.

15 Always switch-off your machine and disconnect the AC plug from the main outlet when the appliance is not in use.

16 Do not use your machine if the AC cord or plug is damaged.

17 If the cleaner is damages it must be repaired by the manufacturer or its service agent in order to avoid a hazard.

18 This appliance is not intended for use by children or other persons without assistance or supervision if their physical sensory or mental capabilities prevent them from using it safely Children should be supervised to ensure that they do not play with the appliance.

19 If the supply cord is damaged it must be replaced by the manufacturer or its service agent in order to avoid a hazard 20 The vacuum cleaner must not be left unattended while it is connected the supply mains.

21 This vacuum cleaner is for household use only

22 The plug must be removed from the socket-outlet before cleaning or maintaining the vacuum cleaner.

Caution:

· Do not overfill the water container

Note the ‘Maximum Level’ marking.

· Do not fill the water container with anything other than water.

· Always empty the dirty water clean and store you machine correctly after each use.

Part and Accessories Index

Brush

Preparation Before Use

1.Setting Up the Product

Remove the water container using the attached handle (Fig 1).

Remove the filter assembly from the water container

Hang up the handle and push 5

down the lock button on the cover (Fig 2).

Fill the container with tap water to ‘Max

Water Level’ indicated on the front of the container This is about 1.3 liters Please ensure the container is not overfilled (Fig.

Assemble the water container back to the body Close and lock the water tank handle The locking mechanism will “Click” when locked.

Insert the flexible hose into the hose socket (Fig 4).

Connect the telescopic tube to the flexible hose.

2.Power On

Extract the AC power cord fully by holding the cord and pull it towards you Do not pull the cord by holding the plug as this will damage the cord.

Connect the plug to a suitable mains power outlet with the correct voltage (Fig 5).

Caution:

Before connect the plug to the power socket unwind a sufficient length of cable A yellow mark on the power cable shows the ideal cable length Don’t expend the cable beyond the red mark

Press firmly and turn on the main

ON/OFF switch One green indicator light will flash The machine is now on ‘Standby’ mode At this stage your machine is ready to work (Fig 6).

Push the standby button on the main body will activate the machine in the lower suction mode

Caution: Make sure the AC power cord is fully extracted During the operation a partially extracted power cord will generate excessive heat.

Use of your product

1.Standby Button

This button is used to switch between standby mode and operation mode The initial push turns the suction power on at the low mode While the machine is operating push this button returns the machine to the standby mode. 2.

Suction Power Selection Button

There are four suction power setting

Low Medium High and Turbo Use (+) or (-) button on the main body of the machine to select the desired setting (Fig 7).

The current suction power is indicated by the number of green indicator lights

Three green lights means the suction power is now in the high position.

3.Telescopic Tube

The extendable Telescopic Tube gives you added flexibility and control Depending on your application and situation you may adjust the length of the Telescopic Tube to suit your needs Push and hold the locking knob extend or retract the telescopic pole as required Release the knob and pull the