Инструкция по эксплуатации Saturn ST-EC0189 — страница 4

5.High voltage pulse protection

During operation when power supply receives a transient high voltage pulse (such as lightning strike) induction cooker will stop automatically and in a minute will resume automatically.

COOKING UTENSIL SELECTION

1.Useable pans.

Steel or cast iron enameled iron stainless steel flat-bottom pans/pots with diameter more than 18.5cm.

2.Non-usable pans.

Heat-resistant glass ceramic container copper aluminum pans/pots Round-bottom pans/pots with bottom diameter less than 18.5cm.

CARE AND MAINTENANCE

1.Please unplug from power outlet before care and maintenance.

2.When ceramic hotplate is dirty wipe it with wet cloth or after wipe it with detergent or burnishing powder clean it with wet cloth.

3.Wipe unit body and control panel with soft and wet cloth neutral cleanser may be used for firm oil stain and then wipe the remained residue with soft and wet cloth.

4.Never rinse directly with water or immense it in water.

5.Keep the unit clean regularly to prevent black beetle entry into the fan so that the unit will fail the surface of air intake and vent may be cleaned (such as dust smear) with cotton bar a little detergent added on the toothbrush may be used for cleaning.

CONTRAST CHART OF THERMAL

EFFICIENCY (based on 1l water)

Cooker type

Time

Gas(or electrici

-ty) consum ption

Thermal efficiency

Induc

-tion cooker

6.7mi n

kw/h

Gas cooker

0.05

Electr

-ic cooker

0.345 kw/h

TROUBLE SHOOTING

If the problem occurs during operation please make the check according to the following table before returning it to repair.

TROUBLE

CHECKING POINT

When plug is inserted into the power outlet a beep sound will not be heard and the indicator will not be lighted when pressing POWER button

Whether the plug is removed from the outlet Whether power switch or fuse in your home is cut off Whether power is cut off

Continuous 15s beep sound will be heard and then the unit stop operating.

Whether the pan is proper

Whether the pan is centered on the hotplate Whether the bottom diameter of the pan is more than 18.5cm

The unit stops heating suddenly during use

Whether ambient temperature is very high

Whether air intake or vent is jammed

It means reaching the set temperature when the unit is at TEMP state

Protection equipment may operate confirm it after waiting from several to 10 minutes

The temperature cannot be controlled when frying or grilling food.

Whether the pan bottom is concavo-convex or the bottom center is concave

Whether power indictor is lighted

The induction cooker will stop heating if the following malfunctions occur after 3s the display will show the malfunction alarm the malfunction code will show on the center of display you can clear the display by pressing the switch button and the appliance will enter the standby mode.

DISPLAY

DIRECTION

check whether the pan is in place

the circuit is malfunctioned

the temperature sensor is open-circuited or short-circuited

the voltage is higher (260V-275V) for 3s

the voltage is lower (165V-190V) for 3s

the cooker surface temperature is higher

IGBT temperature is higher than 95℃ for 3s

the IGBT temperature sensor is open-circuited or short-circuited

CIRCUIT

DIAGRAM