Инструкция по эксплуатации Saturn ST-CH7408 — страница 4

Asia style 1 Boring an air outlet hole:
Make the exhaust duct against the wall and draw a circle around it then bore a hole in the wall with a percussion drilling watch out the structure and metal of the wall so as not to boil the surface of the wall beyond the hole. 2 Installing the organism:

(1) According to the requests shown in figure 9 bore a 40-50mm deep hole in the wall above the stove with

φ8mm drill bit keep the organism level The distance between the bottom of the organism and the stove is 700-750mm

Figure 9

(2) Knock two plug bolts slightly into the open holes (shown in figure 10) then fit two claddings into plug bolts and wind the nuts Make sure that the claddings are fastened to avoid that it may drop from the wall

(3) Set the feet into the open holes at the back of the organism (shown in figure 11) 7

(4) Fit the organism into the claddings (shown in figure 12)

(5) Insert the exhaust duct into the inside and outside tracks of the air outlet and fix with tapping screw

Ensure that the exhaust duct is neither convex nor concave the corner piece is smoothly the connector is narrow and the blades in the air outlet can turn freely Make a pylon of 170mm diameter at the exit of the exhaust duct through which the exhaust duct can reach outdoor or the common smoke pipe The connector must be narrow The waste gas cannot be discharged into the hot flue which is used to discharge the smoke of burning gas or other kinds of fuel

IV Use method