No liability can be accepted for any damage caused by noncompliance with these instructions or any other improper use or mishandling.
The iron should always be turned to
"min" before plugging or unplugging from the mains outlet Never pull the cord to disconnect from the mains: instead grasp plug and pull to disconnect.
Burns can occur from touching hot metal parts hot water or steam use caution when you turn a steam iron upside down-there may be hot water in the reservoir.
If the iron is not operating normally disconnect from the power supply and contact the nearest authorized service agent.
Your iron is designed to rest on the heel Do not leave the iron unattended when switched on Do not place the iron on an unprotected surface even if it is on its heel rest.
FILLING WITH WATER
Ensure the iron is disconnected from the power supply.
Turn the steam control knob to position "0".
Fill with water through water filling inlet (Do not exceed main level mark on the water tank.)
SETTING THE TEMPERATURE
* Synthetics-Silk
** Wool
*** Cotton Linen
Stand the iron upright.
Set temperature control to ironing temperature.
Inset the mains plug into the main supply.
After the indicator light has gone out and come on again you may start ironing
The indicator light will go out from time to time during ironing.
STEAM-IRONNING
Set the temperature control to position** for moderate steam and to
*** for maximum steam
With conventional steam irons water may leak from the soleplate if a too low temperature has been selected.
Ensure that there is enough water in the water reservoir.
Stand the iron on its heel.
Insert the mains plug into the wall socket.
Wait a little while for the indicator light to go out and come on again.
See the variable steam knob to adjust the steam.
BURST OF STEAM
By pressing button an intense
"Burst "of steam is emitted from the soleplate.
To prevent water leaking from the sole plate do not keep the steam control button depressed for more than 5 seconds.
SPRAY SETTING
At any temperature by pressing the spray button a couple of time the laundry can be damped down.
Ensure that there is enough water in the water reservoir.
DRY IRONING
Turn the variable steam knob to the position "O"(=no steam).
STORAGE
Remove the mains plug from the wall socket.
Pour and remaining water out of the water reservoir.
Set the steam knob to no steam position.
Stand the iron upright and let it coot down sufficiently.
CLEANING
Before cleaning the iron ensure it is disconnected from the power supply and has completely cooled down.
Deposits on the soleplate may be removed with a rough cloth soaked in a vinegar/water solution.
The casting may be wiped with a damp cloth and then polished with a dry one.
Do not use abrasives on the soleplate.
Keep the sole plate smooth Avoid hard contact with metal objects.
SELF CLEANING
It is important to apply "self-cleaning" at least every two weeks to remove impurities etc.
The harder the water the more the iron should be self-cleaned.
Open the filling funnel and fill the water reservoir up to the MAX position then close the filling funnel.
Set the temperature control to
MAX.
Insert the mains plug into the wall socket.
Allow the iron to heat up until the temperature pilot light goes out.
Then set temperature control dial to position MIN.
Hold the iron horizontally over the sink then remove the variable steam control knob from the body enabling the 5
iron to self clean.
Boiling water and steam will now be ejected from the holes in soleplate
Impurities are washed away with it
Move the iron forwards and backwards while this happened.
Set the steam control to "O" position when the water reservoir has become empty.
Repeat self-cleaning if you notice that much impurity or other has been washed out.
Move the iron over a (preferably) old piece of cloth This is to ensure that the soleplate will be dry during storage.
Unplug and allow the iron to cool clown before storing it.
Specification
Power: 2000 W
Rated Voltage: 220-230 V
Rated Frequency: 50 Hz
Rated Current:
Iron 1pc
Instruction Manual 1pc
Warranty Book 1pc
Package 1pc
ENVIRONMENT FRIENDLY
DISPOSAL
You can help protect the environment!
Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal centre.
The manufacturer reserves the right to change the specification and design of goods.
УТЮГ
Уважаемый покупатель!
Поздравляем Вас с приобретением изделия торговой марки “Saturn”
Уверены что наши изделия будут верными и надежными помощниками в Вашем домашнем хозяйстве.
Не подвергайте устройство резким перепадам температур
Резкая смена температуры (например внесение устройства с мороза в теплое помещение) может вызвать конденсацию влаги внутри устройства и нарушить его работоспособность при включении Устройство должно отстояться в теплом помещении не менее 1,5 часов Ввод устройства в эксплуатацию после транспортировки производить не ранее чем через 1,5 часа после внесения его в помещение
Описание: 1.
Кнопка распыления воды
2.Кнопка усиленной подачи пара
3.Регулятор степени отпаривания 4.
Окошко для наполнения воды
5.Распылитель воды
6.Декоративная вставка
7.Подошва утюга
8.Регулятор температурного режима
9.Прозрачный резервуар для воды
10 Индикатор работы
Инструкция по эксплуатации Saturn ST-CC7141 — страница 3
Инструкция для Инструкция по эксплуатации Saturn ST-CC7141 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.
Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.