Инструкция по эксплуатации Saturn ST-CC7130 — страница 5

6 Install the steam head to superior tube hooking.

Filling the water fill tank

1 Unplug the power cord and turn the lighted ON/OFF switch to the “OFF” position.

2 Remove the water fill tank; turn it upside down and unscrew the valve cap.

3 Fill the water fill tank with cool water and replace the valve cap.

NOTE: To prolong the lifetime of your steamer we recommend using distilled water.

NOTE: Do not substitute another water tank for the one designed for this unit.

4 Place the water fill tank on the water reservoir

CAUTION: Do not let the steamer operate with a dry water fill tank or damage to the unit could occur.

Quick Storage

1 Turn the ON/OFF switch to “OFF”.

2 Unplug the power cord.

3 Wrap the hose around the telescopic pole one time.

4 Hang the steam nozzle from the steam nozzle holder 5 Loosen the three fasteners on the telescopic pole 6 Push down on the pole top; the pole will collapse to a compact height.

7 Roll the unit to a convenient storage location.

Cleaning and Long-term Storage

We recommend you follow this procedure at least once per week Use of distilled or de-mineralized water reduces the need to clean an prolongs the life of your steam

1 Turn the lighted ON/OFF switch to

“OFF”.

2 Unplug the unit from the power outlet.

3 Wait for the unit to cool completely (at least 30 minutes).

4 Remove the hose and the telescopic pole and set them aside.

5 Carry the unit to a sink or tub.

6 Remove and drain the water fill tank

Rinse the water tank with fresh water and drain completely.

7 Flush the unit by filling the water reservoir and the hose base with fresh water and draining completely.

8 Place the water fill tank bank on the water reservoir.

9 Reattach the telescopic pole and hose.

10 Follow steps 3-6 of the quick storage procedure above.

Troubleshooting

Problem

Cause

Solution

The security device does not work

One of the circuits has fault the plug is loose the fuse burned the

LED of supply source is extinguished

Check and maintain by specialized technician

A noise originates pipe of steam but the produced steam is weak.

The pipe is twisted below level to iron.

Raise the steam pipe (residual water in top returns into the device)

Spray head is

The head is broken or

Replace the spray head leaked the ironing is vertical.

Move from top down to operate.

Hooking connection of steam pipe is leaked.

The cushion can be damaged itself with the aging the junction interface loosen itself

Replace the cushion

Rotate the junction of steam pipe tightly.

Water spilled out water tank

Water tank is broken or has a hole

Replace the water tank

Steam is weak

The power source is lower or deposits can obstruct the arrival pipe

Add a stabilizer of power source Use a cleaning respecting the environment

No steam but the indicator is lighted

The steam creator is broken.

The internal electric component is broken.

Call a specialized technician to do an examination