Инструкция по эксплуатации KORTING OKB481CRC — страница 21

INSTALLATION

After removing the appliance from the pack­

aging make sure that it is undamaged and that the electrical lead is in perfect condition Oth­
erwise contact your dealer before putting the appliance into operation.

IMPORTANT

Be careful not to leave the packing materials (plastic sheeting expanded polystyrene etc.) where children can get at them as they can be dangerous.Installation should be carried out ac­
cording to the instructions by a professionally qualified person.The manufacturer declines all responsibility for any damage to persons ani­
mals or things due to a wrong installation.

Installing the appliance

For the most efficient air circulation the oven should be fitted according to the dimensions shown in fig 2.

Fitting the appliance

Fit the appliance into its surround (beneath a work-top or above another appliance) by insert­

ing screws into the 2 holes that can be seen in the frame of the oven when the door is open (fig 2).

IMPORTANT

The panels of the adjoining furniture should be heat resistant Particularly when the adjoin­
ing furniture is made of veneered wood the ad­
hesives should be able to withstand a temperature of 100°C Plastic materials or adhesive which cannot withstand this tempera­
ture will become deformed or unstuck.

To comply with safety regulations once the appliance has been fitted it should not be pos­
sible to make contact with the electrical parts.

All parts which offer protection should be fixed in such a way that they cannot be removed without the use of a tool.

Electrical connection

Electric connection has to be done according to rules and law provisions in force Before do­

ing the connection check the following:

■ The electric power and sockets are suitable to maximum power of the oven (See data plate on the appliance).

■ WARNING: THIS APPLIANCE MUST BE

EARTHED.

The appliance’s electrical safety can only be guaranteed when it has been correctly connect­
ed to a properly earthed power supply as laid down in the regulations for electrical safety.

Important: the manufacturer cannot be held responsible for any damage to persons or ob­

jects due to the lack of an earth connection.

■ Never use reducers adaptors or branches for connections.

Connecting of feeding cable

If apparatus is not fitted with feeding cable use cable Mod H05RR-F or H05RN-F 3 x 1.5 sq mm stating suitable section of the cable which has to be connected to terminal.

To obtain that you have to:

■ Connect the supply cable to the terminal strip of the oven (fig 3) keeping the earth wire 3 cm longer than the active conductors (live/
neutral)

■ Connect cable’s wires as follows:

L = (live) brown or red wire N = (neutral) blue wire

± = (earth) yellow green wire.

N.B the power supply lead must be posi­

tioned so that it does not reach a tempera­
ture 50°C above the room temperature in any point.

Connection to normal socket

Connect feeding cable a normal plug suit­

able to the load stated on data plate When the cooker has been built-in household check that the plug is accesible.