Инструкция INVOLIGHT BATBAR230 — страница 6

Инструкция

PDF

0,28 МБ

Сценическое оборуд.

МилаDoc252

Инструкция для INVOLIGHT BATBAR230 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

4. SPEED

Under Built-in Program Mode, press “SPEED” button enter into the speed setting mode.

You can set the programs segment running speed by press the“+” or“-”button.

5. STROBE

You will turn off the strobe function when the fixture is under built-in program mode by press “STROBE”.

Oppositely, you will turn on the strobe function. You can set the strobe value by press “+” or “-” button, the strobe

value is ~ .

6. Dimming Mode

a. Press “DIMMING” button and the fixture will enter into Dimming Mode.

b. Press “R”, “G”, “B” buttons respectively and the fixture will enter into single color value setting mode. In

order to get great color effect, please press “+” or “-”button to adjust corresponding single color value

“000~255”. (“A”, “W” button are invalid)

The fixture will enter into static color mode no matter which status it is under if only you press number buttons.

Every number button is respect a static color, please see below table.

Cyan

Purple

Purlish

Red

Orange

White

Bright

Pink

Light

Green

Water

Blue

Yellow

Warm

White

When it is not in Dimming Mode, "R", "G", "B", "A", "W" are static color for RED, GREEN, BLUE, AMBER,

WHITE.

IR will help to restore factory settings by press buttons of “BLACKOUT”+“9”+“8”+“7”.

NOTE:

1. Press the “MODE” and “SETUP” at same time for a few seconds to restore factory settings, the data will be

initialized.

2. Please operate the fixture base on the specification to avoid security incidents,

3. If ambient temperature is beyond the permitted range when you operate the fixture, such as, the temperature is

too high, the fixture will be damaged. Please reduce the using time of it.

4. Please do not operate the fixture with power on for safety.

5. Take out the batteries if you don't use the lamp for a long time. Replace batteries immediately if battery is dead.

6. In DMX mode, if there is a control signal, the display board will flicker for prompting.

Скачать «INVOLIGHT BATBAR230» — 0,28 МБ СкачатьСкачиваний: 0

Инструкция INVOLIGHT BATBAR230 — страница 6

Другие руководства из этой категории