Инструкция по эксплуатации Indesit K 1G210 — страница 5

• Fits firmly into place at both ends where it will be fixed using clamps that comply with current regulations

! If one or more of these conditions is not fulfilled or if the cooker must be installed according to the conditions listed for class 2 subclass 1 appliances (installed between two cupboards) the flexible steel hose must be used instead (see below).

Connecting a flexible jointless stainless steel pipe to a threaded attachment

Make sure that the hose and gaskets comply with current national legislation To begin using the hose remove the hose holder on the appliance (the gas supply inlet on the appliance is a cylindrical threaded 1/2 gas male attachment).

! Perform the connection in such a way that the hose length does not exceed a maximum of 2 metres making sure that the hose is not compressed and does not come into contact with moving parts.

Checking the connection for leaks

When the installation process is complete check the hose fittings for leaks using a soapy solution Never use a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas other than the default type (this is indicated on the rating label on the cover).

Adapting the hob

Replacing the nozzles for the hob burners:
1 Remove the hob grids and slide the burners off their seats. 2 Unscrew the nozzles using a 7 mm socket spanner (see fi gure

) and replace them with nozzles suited to the new type of gas(see Burner and nozzle specifi cations table). 3 Replace all the components by following the above instructions in reverse

Adjusting the hob burners’ minimum setting:
1 Turn the tap to the minimum position. 2 Remove the knob and adjust the regulatory screw which is positioned inside or next to the tap pin until the flame is small but steady. ! If the appliance is connected to a liquid gas supply the regulatory screw must be fastened as tightly as possible. 3 While the burner is alight quickly change the position of the knob from minimum to maximum and vice versa several times checking that the flame is not extinguished

! The hob burners do not require primary air adjustment.

Adapting the oven

Replacing the oven burner nozzle:
1 Remove the oven compartment. 2 Slide out the protection panel A (see diagram).

3 Remove the oven burner after unscrewing the screws V (see fi gure). The whole operation will be made easier if the oven door is removed.

4 Unscrew the nozzle using a special nozzle socket spanner (see fi gure) or with a 7 mm socket spanner and replace it with a new nozzle that is suited to the new type of gas (see Burner and nozzle specifi cations table).

Adjusting the gas oven burner’s minimum setting: 1 Light the burner (see Start-up and Use). 2 Turn the knob to the minimum position (MIN)
after it has been in the maximum position (MAX) for approximately 10 minutes. 3 Remove the knob. 4 Tighten or loosen the adjustment screws on the outside of the thermostat pin (see fi gure) until the flame is small but steady. ! If the appliance is connected to liquid gas the