Инструкция по эксплуатации Indesit K 1G210 — страница 4

200 mm away from its sides. •

Any hoods must be installed according to the instructions listed in the relevant operating manual

Levelling

If it is necessary to level the appliance screw the adjustable feet into the places provided on each corner of the base of the cooker (see fi gure

The legs* fit into the slots on the underside of the base of the cooker.

Electrical connection

Install a standardised plug corresponding to the load indicated on the appliance data plate (see Technical data table

The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains The circuit-breaker must be suitable for the charge indicated and must comply with NFC 15-100 regulations (the earthing wire must not be interrupted by the circuitbreaker) The supply cable must be positioned so that it does not come into contact with temperatures higher than 50°C at any point

Before connecting the appliance to the power supply make sure that:

- The appliance is earthed and the plug is compliant with the law.

• The socket can withstand the maximum power of the appliance which is indicated by the data plate.

• The voltage is in the range between the values indicated on the data plate.

• The socket is compatible with the plug of the appliance If the socket is incompatible with the

HOOD

Min.

min 650 mm with hood min 700 mm without hood mm.

Min.

Min.

* Only available in certain models plug ask an authorised technician to replace it Do not use extension cords or multiple sockets.

! Once the appliance has been installed the power supply cable and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by authorised technicians only.

! The manufacturer declines any liability should these safety measures not be observed.

Gas connection

Connection to the gas network or to the gas cylinder may be carried out using a flexible rubber or steel hose in accordance with current national legislation and after making sure that the appliance is suited to the type of gas with which it will be supplied (see the rating sticker on the cover: if this is not the case see below) When using liquid gas from a cylinder install a pressure regulator which complies with current national regulations To make connection easier the gas supply may be turned sideways*: reverse the position of the hose holder with that of the cap and replace the gasket that is supplied with the appliance

! Check that the pressure of the gas supply is consistent with the values indicated in the Table of burner and nozzle specifications (see below). This will ensure the safe operation and durability of your appliance while maintaining efficient energy consumption

Gas connection using a flexible rubber hose

Make sure that the hose complies with current national legislation The internal diameter of the hose must measure: 8 mm for liquid gas supply; 13 mm for methane gas supply

Once the connection has been performed make sure that the hose:

- Does not come into contact with any parts that reach temperatures of over 50°C.

• Is not subject to any pulling or twisting forces and that it is not kinked or bent

• Does not come into contact with blades sharp corners or moving parts and that it is not compressed.

• Is easy to inspect along its whole length so that its condition may be checked.

• Is shorter than 1500 mm.