Инструкция по эксплуатации Gardena T 1030 Plus — страница 4

ФорматФормат: Руководство СтраницСтраниц: 12 КатегорияКатегория: Кухня ДобавилДобавил: OLD

Инструкция для Инструкция по эксплуатации Gardena T 1030 Plus на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.

Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.

Назад
/ 12
Вперёд
Страница 4
Insert battery :

Test battery :

4 Putting Your Water Timer into Operation

The Water Timer may only be operated with a 9 V alkalimanganese (alkaline) battery type IEC 6LR61.

1 Remove controller 4

from the housing of the Water Timer.

2 Insert battery in the battery compartment 5

Observe correct polarity z

P.

3 Install controller 4

on the housing again.

Before a long period of absence (e.g holidays) the battery should be tested So that the water running off cannot cause damage a specific outlet is to be provided on the Water Timer (connect hose place bucket underneath etc.).

1 Open tap.

2 Turn Run-Time control knob 1

clockwise to ON.

The valve opens.

3 Turn Run-Time control knob 1

to OFF.

The valve closes.

Battery

Battery

Battery sufficiently full almost empty flat

Valve opens.

Valve opens.

Valve does not open.

Battery level LED 3

Battery level LED 3

Battery level LED 3

does not flash.

flashes 5 times.

flashes permanently.

The Water Timer

The Water Timer

The Water Timer is guaranteed to will continue to work stops working.

work for a minimum for no more than of 4 more weeks.

4 weeks.

It is advisable to

The battery must be change the battery.

changed.

The Water Timer is fitted with a sleeve nut 6

for taps with G 1

(33.3 mm) thread The adaptor supplied 7

allows the Water

Timer to be connected to taps with a G

³⁄₄" (26.5 mm) thread.

1 For tap with a G

³³⁄⁄₄₄" (26.5 mm) thread:

Screw adaptor 7

on to the tap manually (do not use pliers).

2 Screw sleeve nut 6

of the Water Timer on to the adaptor thread by hand (do not use pliers).

3 Screw tap connector 8

on to the Water Timer.

Connect Water Timer :
Нашли ошибку?