Инструкция по эксплуатации Elenberg DW-600 — страница 23

PROBLEM

POSSIBLE CAUSE

POSSIBLE SOLUTION

Dishwasher will not start

1 Dishwasher not receiving electrical power

Check electrical connection fuse/
circuit breaker

2 Door is unlatched

Close and latch door

3 Dishwasher not level

Level unit

Dishes not clean 1 Improper loading a) Arrange dishes so spray action reaches all surfaces.
b) Do not overload dishwasher.

2 Spray arm not rotating freely a) Check spray arm to make sure nothing (i.e cutlery) is obstructing spray arm rotation.
b) Check if filter screen has become dislodged and obstructing spray arm rotation.

3 Not enough detergent and/or improper detergent being used.

a) Use more dishwasher detergent.
b) Do not use detergent that is hard or cracked.
c) Use only a recommended dishwasher detergent.

4 Improperly prepared dishes.

Excess food soil and liquids should be removed from dishes before loading.

5 Water inlet hose kinked/bent due to improper installation.

Eliminate kink or bend from Inlet hose.

Chipping or breaking glassware

Improper loading of dishes.

Do not overload dish rack Load glasses on the upper rack only not over dish rack pins Glasses loaded over dish rack pins are not properly supported and subject to damage.

Water remains in bottom

1 A small amount of water (in sump area) is normal.

This is necessary to keep the pump primed and is drained automatically at the beginning of each cycle.

2 Excessive amount of water; cycle not completed.

Allow dishwasher to complete full cycle.

Dishwasher can’t stop

The draft is too much

Drain the water out and clear the filter.

COMMON DISHWASHINg PRObLEMS AND SOLUTIONS