Инструкция по эксплуатации Elenberg DW-600 — страница 17

Electrical Instructions:

An electrical supply of 220-240 volts AC only 50Hz is required Make sure that a suitable electrical supply socket is located close to where the dishwasher is to be placed For your personal safety the appliance must be earthed The appliance is equipped with a power supply cord having a 3-pin grounding plug To minimize possible shock hazards it must be plugged into a matching 3-pin grounding type electrical outlet.

If the mains plug is unsuitable for the socket outlet in your home or is removed for any other reason then the cut off plug should be disposed of safety to prevent the hazard of electric shock

SAVE THESE INSTRUCTIONS

1 Remove all packing materials carefully 2 The water inlet hose from the machine terminates in a ℃” female connector The water supply should therefore terminate in a similar male connector and should have a stopcock close by in the pipe Connect the straight connector of the inlet hose to the water supply securely Connect the other end (bent connector) to the water inlet valve at the back of the dishwasher cabinet Do not over-tighten to avoid damage to threads.

3 Prepare the drainage hose so that it has hooked end Use the plastic U-bend fitting provided for this purpose The end of this should be dropped into a drainage standpipe the maximum height of which should be no more than 6”
above the base of the dishwasher To allow for an air gap around the end of the drain hose the diameter of the standpipe should be at least 30 mm Connect the other end of the drain hose (L shaped) to the drain port connection at the back of the dishwasher cabinet Tighten the drain hose end on to the drain port using the metal clip included in the package.

4 If you so wish you may connect the water inlet hose on to the kitchen sink tap

You must obtain correct fittings/adaptors to match the inlet hose connectors to ensure secure connection However permanent plumbing is recommended.

5 If leaks are located immediately shut the water supply and check the hose connections fully Tighten connections if necessary.

INSTALLATION INSTRUCTIONS