Инструкция по эксплуатации Electrolux EOB6850AOX — страница 34

10.Carefully lift (step 1) and remove (step 2) the glass panels one by one Start from the top panel.

11.Clean the glass panels with water and soap Dry the glass panels carefully.

Installing the door and the glass panel

When the cleaning is completed install the glass panels and the oven door Do the above steps in the opposite sequence Make sure that you put the glass panels back in the correct sequence The second panel has a decorative frame The screenprinting zone must face the inner side of the door Make sure that after the installation the surface of the glass panel frame on the screen-printing zones is not rough when you touch it Make sure that you install the middle panel of glass in the seats correctly (refer to the illustration).

11.5 Cleaning the water tank

WARNING!
Do not put water into the water tank during the cleaning procedure.

During the cleaning procedure some water can drip from the steam inlet onto the cavity of the oven Put a dripping pan on the shelf level directly below the steam inlet to prevent water from falling onto the bottom of the oven cavity.

After some time you can have lime deposits in your oven To prevent this clean the parts of the oven that generate the steam Empty the tank after each steam cooking.

1.Fill in the water tank with 900 ml of water and 50 ml of citric acid (five teaspoons) Deactivate the oven and wait for approximately 60 minutes.

2.Activate the oven and set the True Fan + Steam function Set the temperature 230 °C Deactivate it after 25 minutes and let it cool down for 15 minutes.

3.Activate the oven and set the True Fan + Steam function Set the temperature between 130 and 230 °C.
Deactivate it after 10 minutes Let it cool down and continue with the removal of the tank contents (refer to "Emptying the water tank").

4.Rinse the water tank and clean the remaining lime residue in the oven with a cloth.

5.Clean the drain pipe by hand in warm water with soap To prevent damage do not use acids sprays or similar cleaning agents.

Types of water • Soft water with low lime content

the manufacturer recommends this because it decreases the quantity of cleaning procedures.

34