Инструкция по эксплуатации DUNE TV-301 — страница 14

Dune HD TV-301 Quick Start Guide

Switching the Player On and Off

To put the player into the standby mode press the «POWER» RC button To exit the standby mode press this buttons again Depending on the player settings (see the player setup menu) the «hardware standby» or «software standby» mode may be used In the «hardware standby» mode almost complete power-off takes place and the player consumes almost no power In the «software standby» mode the player produces no signal on the video output but is still functioning For example if you have some storage devices connected to the player you may still access them from network («NAS» function of the player) Exiting the «software standby» mode takes just a few seconds When the player is in the «software standby» mode it still consumes significant power It is not recommended to keep the player in the «software standby» mode for a while if you do not need it To switch the player off completely disconnect the power plug NOTE: After switching off the player completely or putting the player into the «hardware standby» mode it is recommended to wait about 1 minute before switching it on again.

NAS (Network Attached Storage)

You can access storage devices connected to the player from the local network using FTP and SMB protocols On a Windows PC just type «ftp: ip_address» or « ip_address» in the Windows explorer where «ip_address»
is the IP address of the player.

Wi-Fi

If you player does not include a built-in Wi-Fi adapter you can use a USB Wi-Fi adapter to connect the player to the local network via Wi-Fi Please see here for the information on supported USB Wi-Fi adapters: http: