Инструкция по эксплуатации DUNE TV-301 — страница 13

English

Using USB 3.0 Slave Function

To connect the player with an installed internal HDD via USB 3.0 Slave connect the USB 3.0 Slave port of the player to the USB host port of the PC The PC will recognize a new USB device After finishing working with the player in the PC ensure the USB device is correctly stopped in the PC («Safely remove hardware»or a similar function) and then disconnect the USB 3.0 Slave port of the player from the USB
host port of the PC.

Accessing Network Drives

To connect a network drive using SMB or NFS protocol ensure you are on the main screen of the player menu press the “MENU” RC button and choose “Create Network Folder” then fill the parameters of the network drive as needed The player will show an item corresponding to the configured network drive on the main screen To browse the list of network resources accessible via SMB or UPnP protocols use “Network Browser” item on the main screen of the player menu.

NOTE: If some network resources are not shown by the player you may need to wait some minutes and then retry (or press the “MENU” RC button and choose “Refresh” command).

Formatting HDD

To format an HDD attached to the player select the HDD item on the main screen of the player menu press the “INFO” RC button and choose “Format Disk” (to format the entire disk) or “Format Partition”
(to format an already existing disk partition only) The player will format the disk To format an unformatted HDD just press the “ENTER” RC button on the HDD item.

NOTE: To use disks formatted by the player on a Windows PC you may need to install additional software on the PC such as “EXT2FSD” (http: