Инструкция по эксплуатации Bosch Tronic 2000 — страница 12

Product description

This instruction manual describes various appliance models.

General

• The hydraulically controlled flow-through water heater is suitable tor either an open (depressurised) or closed (pressurised) connection.

• The flow-through water heater continuously heats water while it flows through the appliance.

• The appliance must not be operated with preheated water otherwise the overtemperature protection will be triggered.

• These appliances are designed for permanent electrical connection.

ED6-2S high level appliance

ED5-S/U under counter appliances

For the qualified engineer

Preparation for installation

For all appliances

• There must be a clearance of approximately 60 mm on all sides of the appliance for installation.

• Observe the technical data for the appliance

• Flush the cold-water supply line and shut it off.

• Unscrew the screws on the housing cover and remove the lid.

Wall mounting

For all appliances

• Secure the appliance using the installation template screws and wall plugs so that it is vertical and flush against the wall.

1 Locate the appliance on the screw and press down.

2 Screw in the second screw through the mounting tab and tighten.

• For an exposed electrical connection the different methods of routing the supply line found on the assembly template must be observed.

• The cable bushing must firmly enclose the connecting cable to ensure that it is protected against moisture In the event of damage seal the opening so that it is watertight.