Инструкция по эксплуатации Binatone SI-5000 — страница 6

ENGLISH

While holding the iron in a vertical position aim its sole plate towards the articles to be ironed and push the Select Knob (7)

to produce a directional strong burst of steam from the sole plate Push the button several times with 5-7 seconds intervals until the article is fully refreshed If during the process your water tank (5)

(5) runs out of water disconnect the appliance from the mains outlet refill the tank and plug the appliance back into the power supply and continue the process.

Spray

Turning the Select Knob (7)

(7) to the position water spray « »

will help when ironing details of the article (cuffs trimmings plackets etc) or clothes which demand low temperature ironing when steam ironing is not possible Push the Select knob (7)

(7) several times to moisten the material.

Self-Cleaning

Your iron has a self-cleaning function which allows you to clean the internal parts of the appliance from scale or dust To use this function perform the following procedure:
1 Turn the Select knob (7)

(7) to the position « ».

2 Fill the tank (5)

(5) with water to the «Max

Max» level.

3 Place the iron in a vertical position and plug it into the mains supply outlet.

4 Set the Fabric Setting indication (9) to «ËÅÍ» position (see

Figure B) and let iron heat until indicator light (10) stops blinking.

5 When the iron reaches the maximum temperature the indicator light (10) will stop blinking Set Fabric Setting indication (9) to «РЕЖИМЫ» and «

» position.

6 Whilst holding the appliance horizontally over a sink turn the

Select Knob (7)

(7) to the «SELF-CLEAN

SELF-CLEAN

SELF-CLEAN

SELF-CLEAN

SELF-CLEAN» position Hot steam will discharge from the sole plate (11)

(11)

(11)

(11)

(11) removing the scale and dust.

7 If the blast of steam becomes weaker repeat steps 4-6 several time When the water tank (5)

(5) is completely empty turn the

Select knob (7)

(7) to the position « ».

8 Put the appliance into a vertical position and re-heat the iron.

9 To complete the cleaning process; Iron a piece of a clean old cotton cloth in order to clean the sole plate (11)

(11)

(11)

(11)

(11) of any remaining dust and scale and to evaporate the remaining water When you have finished ironing always switch the appliance off and disconnect from the electrical supply.

Auto stop

For safety reasons your iron will automatically stop heating if it’s left:

upright for 8-10 minutes or

flat for 30-35 seconds.

The Color Changeable indicator (10)

(10)

(10)

(10)

(10) will slowly blink at the same time the buzzer will beep six times The iron will heat up again when you move it and the operation light will stop blinking.

To deactivate automatic shut off stand iron on heel or shake gently then the iron will switch on again.