Инструкция по эксплуатации Binatone SI-4060 — страница 7

Press and hold on the control button (16) of the ionized steaming function The blue internal indicator (17) turns on in this case showing that smaller steam particles deeply get into the most difficult ironing fold and eliminate the wrinkle to be easier Light clicking during this process is a normal occurrence and not a malfunction.

5 When you have finished cleaning or ironing do not forget to switch the iron off by putting the steam control knob (9) and the temperature control knob (10) into the «0» position and unplugging the appliance from the mains supply outlet.

MAINTENANCE

Cleaning of the sole plate

Do not use any abrasive substances and materials to clean the sole plate.

Cleaning of internal parts of the appliance

SI-4060 iron is equipped with an anti-scale function which protects it from an accumulation of scale: it does this with a built-in permanent filter Therefore the water hardness is reduced and the useful service life of the iron is extended.

Warning:

In areas with very hard water it is recommended that you regularly remove scale from the appliance to maintain it in good working order Excess lime scale may result in damage or malfunction of your product.

If in your area the water is soft and you have average amounts of clothes to be ironed then we recommend you to de-scale every 6 months If the water in your area is very hard or if you iron frequently then we recommend you de-scale once a month.

Your iron has a self-cleaning function which allows you to clean the internal parts of the appliance from scale or dust To use this function perform the following procedure:
1 Set the steam control knob (9) into the «0» position.
2 Fill the tank (5) with water to the «Max» level.
3 Place the iron in a vertical position and plug it into the mains supply outlet.

4 Set the temperature control knob (10) into the «Max» position The light indicator (11) will light up showing that the iron is being heated to the desired temperature.

5 When the iron reaches the maximum temperature the light indicator (11) will go out.

6 Whilst holding the appliance horizontally over a sink set the steam control knob (9) into the «Self-Clean» position Hot steam will discharge from the sole plate (12) removing the scale and dust If the blast of steam becomes weaker set the control knob (9) into the «0» position and wait for 12-15 seconds until the iron gets hot again Then once again set the control knob into the «Self-Clean» position.

7 When the water tank (5) is completely empty set the steam control knob (9) into the «0» position.