Инструкция по эксплуатации Binatone SI-2550 — страница 5

tank (5)

(5) runs out of water disconnect the appliance from the mains outlet wait till it cools down refill the tank and plug the appliance back into the power supply and continue the process.

Spray

Using the water spray (7)

(7) will help when ironing details of the article (cuffs trimmings plackets etc) or clothes which demand

«•» (low temperature) ironing when steam ironing is not possible.

Push the button several times to moisten the material.

5 When you have finished cleaning or ironing do not forget to switch the iron off by putting the steam control knob (9)

(9) and the temperature control knob (10)

(10)

(10)

(10)

(10) into the «0» position and unplugging the appliance from the mains supply outlet.

CARE AND MAINTENANCE

Cleaning of the sole plate

The scale on the sole plate can be removed with a rough cotton cloth dampened with a vinegar solution.

Do not use any abrasive substances and materials to clean the sole plate.

Cleaning of internal parts of the appliance

SI-2550 iron is equipped with an anti-scale function which protects it from an accumulation of scale: it does this with a built-in permanent filter Therefore the water hardness is reduced and the useful service life of the iron is extended.

Warning:

In areas with very hard water it is recommended that you regularly remove scale from the appliance to maintain it in good working order Excess lime scale may result in damage or malfunction of your product.

If in your area the water is soft and you have average amounts of clothes to be ironed then we recommend you to de-scale every 6

months If the water in your area is very hard or if you iron frequently then we recommend you de-scale once a month.

Your iron has a self-cleaning function which allows you to clean the internal parts of the appliance from scale or dust To use this function perform the following procedure:

1 Set the steam control knob (9)

(9) into the «0» position.

2 Fill the tank (5)

(5) with water to the «Max» level.

3 Place the iron in a vertical position and plug it into the mains supply outlet.

4 Set the temperature control knob (10)

(10)

(10)

(10)

(10) into the «Max» position.

The light indicator (11)

(11)

(11)

(11)

(11) will light up showing that the iron is being heated to the desired temperature.

5 When the iron reaches the maximum temperature the light indicator (11)

(11)

(11)

(11)

(11) will go out.

6 Whilst holding the appliance horizontally over a sink set the steam control knob (9)

(9) into the «Self-Clean» position Hot steam will discharge from the sole plate (12)

(12)

(12)

(12)

(12) removing the