Инструкция по эксплуатации Binatone SI-2550 — страница 4

ENGLISH

INSTRUCTIONS FOR USE

1 Place the iron into a vertical position.

2 Insert the power plug (13)

(13)

(13)

(13)

(13) into the mains supply outlet.

3 Turn the temperature control knob (10)

(10)

(10)

(10)

(10) to set the temperature recommended by the manufacturer of the textile article (usually indicated on the article’s label).

Note:

In case the manufacturer’s recommendations are missing select the temperature setting which corresponds to the type of the cloth to be ironed (see section «Useful advice»).

4 The operation indicator (11)

(11)

(11)

(11)

(11) will light up to indicate that the iron is being heated to the set temperature level When the set temperature level is reached the light indicator (11)

(11)

(11)

(11)

(11) will turn off.

Note:

During operation of the appliance the light indicator will light up and turn off periodically; this is normal and not a malfunction.

Steam ironing

Dry ironing can be can be used at any temperature setting To do this the steam control knob (9)

(9) must be put into the «0» position If you intend to use the steam function allow the iron to heat to the required temperature level then put the control knob (9)

(9) into the required position.

Attention:

Application of the steam ironing function is impossible at «•» temperature setting SI-2550 iron: the «Drip Stop» system automatically terminates the steam generation process if the selected temperature is too low When the system is activated you may hear a click.

Turbo steam

To ease ironing of dense cotton linen and upholstery articles use the steam burst button (8)

(8): engagement of the button (8)

(8) during the ironing process generates an extra burst of steam from the sole plate to help remove stubborn creases.

Burst of steam in a vertical position

This function helps to freshen the appearance of curtains jackets coats etc To use this function take the following steps:

Follow instructions in paragraph 1-4 of the section «Operation instructions» While selecting the temperature setting put the temperature control knob (10)

(10)

(10)

(10)

(10) into the «Max» position.

While holding the iron in a vertical position aim its sole plate towards the articles to be ironed and push the steam burst button (8)

(8) to produce a directional strong burst of steam from the sole plate Push the button several times with 5-7 seconds intervals until the article is fully refreshed If during the process your water