Инструкция по эксплуатации Binatone MGR-3040 — страница 6

ENGLIS

Attention: never use frozen meat!

3 Assemble the meat grinder and plug it into a power supply with voltage matching the information on the appliance.

4 Put the meat into the tray (6).

5 Switch on the appliance using the On/Off button (2) The blue light indicator (19) will light up.

6 Gradually push the meat pieces into the funnel using the pusher (7) Do not push too hard.

7 After use switch the appliance off and unplug it from the wall outlet.

Note:

The grinder will mince up to 2.7 kg of meat per minute.

If the operation slows down or the motor stops it means that probably some pieces of meat are stuck in the grinder Immediately switch the appliance off After stopping the engine press briefly button REV (3)
This will facilitate movement of meat in the opposite direction Release the button (3) and switch the grinder on again If the meat is still stuck in the grinder switch it off and unplug it from the wall outlet Disassemble and wash the appliance according to instructions.

Attention! Reverse mode should be used only for a short period of time and only in case of strong necessity During long operation period using this mode processed food like liquid can get inside the engine compartment and thus cause the damage of the unit.

Use of the shredder and slicer

The slicer (17) is intended for grating products into thin pieces.

This grater is ideal for carrot beet horse radish cheese etc.

The shredder (18) is intended for coarse shredding It is ideal for cabbage cucumbers onion etc.

1 To attach feeding containers (15) to the housing (1) insert it into the opening in the housing push gently and turn anticlockwise until it is properly fastened.

2 Put the selected attachment (17 18) into the feeding container (15) to fit the slots on the attachment with the projections on the operation unit The attachments (17,18) should completely go into feeding container (15).

3 Push on the product with the pusher (16).

Use of the kebbe attachment

1 Insert the screw (8) into feeding container (5).

2 Put the two-element Kebbe attachment (14) onto the end of the screw (8) Make sure the projections on feeding container (5)

match the slots on the attachment Tighten the feeding container nut (11).

3 Fasten the assembled feeding container (5) onto the housing (1).