Инструкция по эксплуатации Bang & Olufsen Playmaker - User Guide — страница 8

> Enter the IP address

‘http: 169.254.11.22’ in the address bar of your Internet browser and press ‘Enter’.*

If the web page is not displayed wait a while and refresh the page

> Select the menu ‘NETWORKS’ and follow on-screen instructions

> Disconnect Playmaker from your computer.

> When the network indicator becomes solid white Playmaker is connected to the network and you can now stream music from your device.

*If you use Internet Explorer version 7 or high er is required.

Make a wired connection For the most reliable network connection use Bang & Olufsen recommended cables only

Wired setup …
> Connect Playmaker directly to the router using an Ethernet cable.

> Connect Playmaker to the mains supply to switch on the product.

> The network indicator flashes white.*

Then it becomes solid white and Playmaker is connected to the network and you can now stream music from your device.

If a static IP setup is needed see the Playmaker section on www.

Software update If available you can update your Playmaker with new software

Software update is performed using the Playmaker setup page

This requires an Ethernet cable and

Internet connection (See ‘Make a wired connection’) During software update the Mute/
standby button flashes red.*

Factory reset

To return to default settings you can reset your Playmaker Note that you must set up Playmaker again after a factory reset You cannot perform a factory reset if the network indicator is flashing red or flashing white

> Insert a small pin such as a straightened paper clip in the reset button hole for minimum five seconds.*

> The network indicator and the

Mute/standby button become solid orange for five seconds

> The product restarts automatically and is reset to default settings.

> You can also reset your product via http: 169.254.11.22 or the BeoSetup App 9

NOTE! Make sure the cable connection between the product and the router does not exit the building to avoid contact with high voltage.

NOTE! You may not be able to use your workplace computer for setup of Playmaker due to security restrictions including firewall settings and assignment of IP
addresses.