Инструкция по эксплуатации Yamaha RX-V863 — страница 6

GETTING STARTED

■ Installing batteries in the remote control

Press the part and slide the battery compartment cover off.

Insert the four supplied batteries (AAA R03 UM-4) according to the polarity markings (+ and –) on the inside of the battery compartment.

Slide the cover back until it snaps into place

• Change all of the batteries if you notice the following conditions:
– the operation range of the remote control decreases. – the transmit indicator (2) does not flash or its light becomes dim.

• Do not use an old battery together with a new one.

- Do not use different types of batteries (such as alkaline and manganese batteries) together Read the packaging carefully as these different types of batteries may have the same shape and color.

• If the batteries have leaked dispose of them immediately Avoid touching the leaked material or letting it come into contact with clothing etc Clean the battery compartment thoroughly before installing new batteries.

• Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations.

• If the remote control is without batteries for more than 2 minutes or if exhausted batteries remain in the remote control the contents of the memory may be cleared When the memory is cleared insert new batteries set up the remote control code and program any acquired functions that may have been cleared.

■ VOLTAGE SELECTOR

(Asia and General models only)

Getting started

Notes

Caution The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.

Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver Voltages are as follows:
Asia model 220/230–240 V AC 50/60 Hz General model 110/120/220/230–240 V AC 50/60 Hz

230-

240V

VOLTAGE

SELECTOR

Voltage indication