Инструкция по эксплуатации WORX Tools WU661 — страница 8

Belt Sander

changing accessories or storing power tools Such preventative safety measures reduce the risk of starting the power tool accidentally.

d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool Power tools are dangerous in the hands of untrained users.

Maintain power tools Check for misalignment or binding of moving parts breakage of parts and any other condition that may affect the power tool’s operation If damaged have the power tool repaired before use Many accidents are caused by poorly maintained power tools.

f) Keep cutting tools sharp and clean

Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.

g) Use the power tool accessories and tool bits etc in accordance with these instructions and in the manner intended for the particular type of power tool taking into account the working conditions and the work to be performed Use of the power tool for operations different from intended could result in a hazardous situation.

5 SERVICE

Have your power tool serviced by a qualified repair person using only genuine replacement parts This will ensure that the safety of the power tool is maintained.

6 SPECIFIC SAFETY RULES

Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring Contact with a‘live’wire will also make exposed metal parts of the tool ‘live’ and shock the operator

ADDITIONAL SPECIFIC

SAFETY INSTRUCTIONS

FOR BELT SANDER

Remove the plug from the socket before carrying out any adjustment servicing or maintenance. 1 Fully unwind cable drum extensions to avoid potential overheating.

2 When an extension cable is required you must ensure it has the correct ampere rating for your power tool and is in a safe electrical condition.

3 Ensure your mains supply voltage is the same as indicated on the rating plate.

4 Your tool is double insulated for additional protection against a possible electrical insulation failure within the tool

5 Always check walls floors and ceilings to avoid hidden power cables and pipes.

6 After long working period external metal parts and accessories could be hot.

7 Wear eye protection when operating this tool 8 If possible ensure the workpiece is firmly clamped to prevent movement.

9 Your belt sander is a hand held tool do not clamp your belt sander.

10 Before sanding check the area is free of nails screws etc.

11 Never stop the belt sander paper by applying a force to the belt.

12 Only use belt in good condition Do not use with a torn or worn belt.

13 Do not sand material containing asbestos due to a health risk.

14 Do not eat or drink in the working area of the sander.

15 Do not allow people to enter the working area without wearing the correct type of mask.

16 Where possible seal off the working area to contain the dust for later removal.

17 Always wear a dust mask. 18 Your tool is designed for dry sanding only not wet sanding.

19 Your tool is designed for general-purpose light polishing of wood and metals.

20 Do not sand magnesium material due to the risk of fire.

RU-WU661-M-060817.indd 8

2006-8-17 16:27:36