Инструкция по эксплуатации ViTESSE VS-755 — страница 3

7 Assemble the accessories on the body case.

5 Assemble the stick into the body case.

Press the button on the stick We can pull out the stick from the body case.

6 Assemble the turbo brush

Press the button at the bottom of the body case We pull out the brush from the body case.

ASSEMBLY

Warning: Always unplug from electrical outlet before opening the dust cup (container) (5).

Note: Dust cup filter (6) must be used when operating the hand vacuum.

1 To open the dust cup (container) (5) push button (2)and pull out the dust cup (5).

Verify that the dust cup filter (6) is inside then attach the dust cup (container) (5) to the hand vacuum.

2 To attach the Upholstery Nozzle (7) or crevice brush (8) to the vacuum cleaner push brush into the suction hole (1) as shown below.

3 Put the appliance into the body case

4 Also we can put the appliance out of the case a Pull the button on the body case to the back position b Put the vacuum cleaner out of the body case.

HOW TO OPERATE YOUR HANDY VACUUM

• Hold the hand vacuum firmly with your hand on the Handle (4).

- Push the

I O Power Switch (3) to “ ” position.

• Start vacuuming.

CAUTION:

The Hand Vacuum is a very powerful unit Make sure that you hold it firmly otherwise it can slip out of your hand and cause injury.

CHANGING & CLEANING THE DUST CUP FILTER

Warning:

Always unplug from electrical outlet before opening the Dust Cup (container) (5).

• To open the Dust Cup (container) (5) push button (2) and pull out the Dust Cup (container) (5) (fig.1).

• Pull out the Dust Cup Filter (6) (fig.2).

- Empty the dust from the Dust Cup Filter (6).

- Rinse the Dust Cup Filter (6) in cold water and then wait until it dries up before replacing it into the Dust Cup (container) (5).

• Place the Dust Cup Filter (6) carefully into the Dust Cup (container) (5).

- Attach the Dust Cup (container) (5) to the Hand Vacuum.

fig.2

CAUTION:

The suction hole (1) must be open free of any obstructions at all time

Otherwise the motor will overheat and could get damaged.

fig.1