Инструкция по эксплуатации ViTESSE VS-754 — страница 3

Operation and function 1 Starting 2 Fitting removing the flexible hose 3 Fitting Removal of the suction tubes/floor nozzle 4 Pulling out rewinding the cable

Before starting your vacuum cleaner for the first time check that all filters are inserted correctly Important: the cleaner cover will only close if the dust filter is inserted

Fit the flexible hose to the suction opening on the upper side of the housing Press the hose connection into the air inlet until you feel it click into place Press the button on the hose connection and pull the hose out again

The metal tubes consist of 2 pieces The two tubes and the adjustable floor nozzle are connected by pushing t o g e t h e r a n d t u r n i n g a n d disconnected by pulling and turning

Pull the cable out far enough to be able to work comfortably Then insert the plug into the power socket The mark indicates the ideal working length Do not pull the cable out any further than the red mark To rewind the cable press the rewind button while feeding the cable back in with the other hand to prevent damage to the housing by the cable 5 Use of the adjustable floor nozzle

Note: 6 Changing the motor filter 7 Replacing the exhaust air filter 8 Power Control 9 Auxiliary air regulator 10 Switching On and Off

The floor nozzle can be adjustable manually and is suitable for bother carpets and for hard floor coverings (the brushes should project for hard floor coverings)

Please also observe the cleaning and care instructions of your floor covering suppliers

The motor filter protects the motor against dust residue The motor filter is located between the dust container and the motor and is removed after first opening the vacuum cleaner The filter must be replaced if it is obviously damaged Otherwise simply shake or blow the dust out Replace the filter in its housing Ensure that the filter is sitting straight in its housing and closed evenly

The exhaust air filter ensures clean air during the vacuuming process The filter should be replaced regularly whenever it becomes dirty To remove the exhaust air filter open the vacuum cleaner and remove the filter grill Now remove the filter from the grill Insert the new filter into the grill and refit it to the rear side of the unit Ensure that the filter is sitting straight in its housing and closes flush.

The Electronic power control is used to adjust the vacuum performance to the cleaning situation in question by means of the rotary power switch.

The auxiliary air regulator is used for the easy temporary reduction of the vacuum performance Open the auxiliary air regulator only as far as required until the vacuum nozzle can be moved easily

The vacuum cleaner is switch on/off by pressing the on/off switch.

Note:

If the vacuum cleaner is to be used for longer than 30minutes the power supply cable should be pulled out at 2 3 of its total length to prevent danger of over heating and damage