Инструкция по эксплуатации ViTESSE VS-704 — страница 3

Support or press the centre of the cutting plate with one finger then screw the fixing ring until tight with another hand (fig.4) Do not over tighten.

Holding the head and insert it in the inlet with one hand tighten it clockwise to secure the head (fig.5,6)

Place the hopper plate on the head and fix into position.

Locate the unit on a firm place

The air passage at the bottom and the side of the motor housing should be kept free and not blocked.

MINCING MEAT •

Cut all foods into pieces (boneless and fatless meat is recommended approximate size :20 mm x 20 mm x 60 mm) so that they fit easily into the hopper opening.

Plug in and turn the “R ON” switch to "ON" position then turn the “ON/OFF/
Reverse” switch to "ON" position.

Feed foods into the hopper plate Use only the food pusher (fig.8).

After use switch the unit off and unplug it from the power supply.

REVERSE FUNCTION •

In case of jamming switch the appliance off by turning the “R ON” switch to "R" position and “ON/OFF Reverse” switch to "R" position Feed screw will be rotating in the opposite direction and the head will get empty.

If it doesn't work switch the unit off plug out and clean it.

MAKING KIBBE RECIPE STUFFING

Mutton 100g Olive oil 1 tablespoons Onion (cut finely) 1 tablespoons Spices to your taste Salt to your taste Flour 1 tablespoons •

Mince mutton once or twice.

Fry onion until brown and add minced mutton all spice salt and flour.

OUTLET COVER Lean meat 450g Flour 150-200g Spices to your taste Nutmeg (cut finely) 1 Powdered red pepper to your taste Pepper to your taste •

Mince meat three times and mix all ingredients together in a bowl More meat and less flour for outlet cover creates better consistency and taste.

Grind the mixture three times.

Disassemble by reversing the steps from 5-3 to remove the cutting plate and cutting blade.

Place kibbe attachments A and B onto the feed screw shaft together fitting protrusions in the slots (fig.9). •

Screw fixing ring into place until tight Do not over tighten (fig.10).

Make the cylindrical outlet cover (fig.11)

MAKING SAUSAGE •

Before starting please assemble sausage attachment as per following (fig.12)

CLEANING AND MAINTENANCE DISASSEMBLING •

Make sure that the motor has stopped completely.

Disconnect the plug from the power outlet.

Disassemble by reversing the steps from (fig.6) pictures.