Инструкция по эксплуатации ViTESSE VS-667 — страница 3

Please note:

Use tap water only Distilled and demineralised water makes the “ Z e r o C a l c ” a n t i c a l c s y s t e m i n e f f e c t i v e b y a l t e r i n g i t s physicochemical characteristics.

Do not use chemical additives scented substances or decalcifies Failure to comply with the above-mentioned regulations leads to the loss of guarantee.

ANTI-DRIP SYSTEM With the anti-drip system you can perfectly iron even the most delicate fabrics Always iron these fabrics at low temperatures The plate may cool down to the point where no more steam comes out but rather drops of boiling water that can leave marks or stains In these cases the Anti-drip system automatically activates to prevent vaporization so that you can iron the most delicate fabrics without risk of spoiling or staining them.

GENERAL INSTRUCTIONS When using the iron for the first time you may notice a slight emission of smoke and hear some sounds made by the expanding plastics This is quite normal and it stops after a short time We also recommend passing the iron over an ordinary cloth before using it for the first time.

PREPARATIONS Soft the laundry to be ironed according to the international symbols on the garment label or if this is missing according to the type of fabric.

Start ironing the garments requiring a low temperature This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.

STEAM IRONING Filling the reservoir

Check that the plug is disconnected from the socket.

Move the steam selector (3) to “0” [Fig 1].

open the filler door (2) press down the lid.

Raise the tip of the iron to help the water enter the opening without overflowing.

Slowly pour the water into the water tank(9) using the special measure (14) and taking care not to go over the maximum level (about 300ml) indicated by “MAX” on the reservoir [Fig 2].

close the filler door (2) press down the lid again.

Selecting the temperature.

Put the iron in a vertical position.

Put the plug in the socket.

Adjust the thermostat knob (10) according to the international symbol (11)on the garment label [Fig 3] The plate temperature control light (6)
indicates that the iron is heating up Wait until the plate temperature control light goes off before ironing Warning: During ironing the plate temperature control light (6) comes on at intervals indicating that the selected temperature is maintained If you lower the thermostat temperature after ironing at a high temperature do not start ironing until the plate temperature control light comes on again Selecting the steam The quantity of steam is regulated by the steam selector (3).

Move the steam selector to a position between minimum and maximum depending on the quantity of steam required and the temperature selected [Fig 1].

Warning: The iron gives off steam continuously only if you hold the iron horizontally You can stop the continuous steam by placing the iron in a vertical position or by moving the steam selector to “0” As indicated on the thermostat knob (10) and in the initial table you can only use steam at the highest temperatures If the selected temperature is too low water may drip onto the plate.

Selecting Shot-steam and steam when ironing Press the shot-steam button (5) to generate a powerful burst of steam that can penetrate the fabrics and smooth the most difficult and tough creases Wait for a few seconds before pressing again [Fig 4]. .Warning: The shot-steam function can only be used at high temperatures Stop the emission when the plate temperature control light (6) comes on than start ironing again only after the light has gone off.

DRY IRONING To iron without steam follow the instructions in section “steam ironing” leaving the steam selector (3) on position “0”. Spray Function Make sure that there is water in the water tank(9) Press the spray button (4) slowly (for a dense spray) or quickly (for a vaporized spray) [Fig.5]. Warning: For delicate fabrics we recommend moistening the fabric beforehand using the spray function or putting a damp cloth between the iron and the fabric To avoid staining do not use the spray on silk or

GARMENT

LABEL

FABRIC

TYPE

THERMOSTAT REGULATION

synthetic silk wool

Cotton linen

low temperature

medium temperature

high temperature

Fabric not to be ironed