Инструкция по эксплуатации ViTESSE VS-660 — страница 3

Steam ironing:
1 Fill the iron as described in the section “how to fill the water tank”. 2 Plug the iron into the mains. 3 Steam ironing is only possible when the highest temperatures shown on the temperature control are selected.Otherwise water may escape through the soleplate.

4 Wait until the pilot light goes out which indicates that the selected temperature has been reached.

5 Turn the steam button to the required position. 6 When the ironing is finished and during breaks in ironing place the iron in its upright position.

7 Disconnect the iron from the mains supply Pour of any remaining water and leave the iron to cool off.

Spray 1 The spray can be used in any position either in dry or steam ironing a long as the water tank is filled with water.

2 Press the spray button for this function NOTE: This button has to be pressed repetitively to start this function for the first time.

Shot of steam Shot of steam give extra steam for removing persistent wrinkles. 1 Place the temperature selector at the “max”(fig.4)position and wait until the pilot light goes out

2 Wait for a few seconds for the steam to penetrate the fibre before pressing again.

NOTE: For the best steam quality do not use more than three successive bursts each time Several pumping actions are needed to start this function Excessive use of this feature will cause the iron to cool ensure that the pilo light is out before operating the shot of steam control

Dry ironing:
Turn the steam control to minimum position set the temperature button to the suitable position you can dry ironing.

Self cleaning:
Set the temperature control to the maximum position; press the self clean button for about 1 minter strong steam will be sprayed to clean the steam chamber Use the function once every two weeks

Anti-drip:
This iron is equipped with a drip stop function: the iron automatically stops steaming when the temperature is too low to prevent water from dripping out of the soleplate.

Suggestions before using the iron for the first time 1 Certain parts of the iron have been lightly greased therefore the iron could give off a little smoke when plugged in for the first time This will cease after a short while.

2 Before using the iron for the first time remove the plastic protector from the base and clean the base with a soft cloth.

3 Keep the base very smooth Do not run it over metal objects (such as against the ironing board buttons zips etc.)

4 Pure wool fibers (100% wool) can be ironed with the appliance in the team position by preference select a high steam position and use a dry ironing cloth.

Selecting the temperature 1 Check the ironing instructions on the garment to be ironed. 2 If the garment does not have any ironing instructions but you know the kind of fabric in question use the chart below.

3 Fabrics that have some kind of finish (polishing wrinkles contrasts….)

can be ironed at the lowest temperatures.

4 If the fabric contains several kinds of fibers always select the temperature applicable if an article contains 60% polyester and 40%
cotton you must always choose the temperature corresponding to polyester and without steam.

5 First classify the articles to be ironed according to the most suitable ironing temperature: wool with wool cotton with cotton etc as the iron heats up as fast as it cools start by ironing the articles requiring the lowest temperature s u c h a s t h o s e m a d e o f s y n t h e t i c f i b e r s P r o g r e s s towards those that require the highest temperatures

6 Press the temperature control button (fig.0) until it is in underside of the appropriate signal according to the following:

Position for nylon and acetate (fig.1)

Position for wool silk or mixtures(fig.2)

Position for cotton (steam) (fig.3)

MAX Position for linen (steam) (fig.4)

Filling water :
1 Unplug the iron. 2 Set the steam button to position (fig.5)
3 Fill the tank through the filling hole (fig.6)

If you have hard water it is advisable to use only distilled water. do not use chemically de-limed water or perfumed

4 Do not store the iron with water in the tank.