Инструкция по эксплуатации Vitek VT-6600 — страница 4

English

• Do not connect FM antenna to outer aerial

• Disconnect from wall outlet before cleaning Use soft damp cloth for cleaning the unit It is forbidden using liquid or aerosol detergents.

Attention!
Follow the instructions listed below in order to avoid unit damages:

Install battery correctly following polarity according to marks on the unit.

• If you are not going to use the unit for a long time extract the battery.

• Replace the battery in proper time.

Connecting to AC power supply line This appliance is powered by AC mains supply voltage 0-0 V and frequency 50 Hz Make sure mains voltage meets unit’s operating voltage before connection.

Battery power supply This appliance is equipped with batteries used as reserve power source Do following to enable batteries:
1 Disconnect the unit from the wall outlet. Open battery compartment lid (1). Insert battery of CR 0 type V following polarity (not included into delivery set).

4 Close battery compartment lid.

Setting current time 1 Holding button () depressed set hour digits by clock set button (6). Similarly holding button () depressed set minutes digits by minutes set button (4).

Setting alarm You can use tuner as source of alarm sound signals Set switch () into position Radio.

1 Holding alarm set button (8) depressed set hour digits by clock set button (6)

Similarly holding button (8) depressed set minutes digits by minutes set button (4)

Press button ALARM On/Off (5) to switch alarm on Symbol of alarm will appear on LCD Pre this button once more to switch alarm off Symbol of alarm will go out.

6600IM.indd 4

25.12.2007 14:44:02