frame will switch on and off automatically Brightness: Display brightness selection from 1 to 16 Contrast: Display contrast selection from 1 to 16 Saturation: Display saturation selection from 1 to 16 Time zone:
Local time setting using time shift Time date: Date and time setting Date format: Date format selection: day/month or month/day Time format: Time format selection: 12 or 24 hours Alarm: Setting alarm actuation time switching on and off Receipt from external sensor:
Automatically– default setting Search – searching signals from remote sensor Weather forecast: Weather conditions selection:
Pressure units: Pressure unit selection: hPa mmHg inHg & mb External channel displaying:
Automatically – Data displaying from the found channels Only 1 channel – Data displaying from the 1 channel Only 2 channel – Data displaying from the 2 channel Only 3 channel – Data displaying from the 3 channel Settings reset: yes/no Weaving version: W232-R 1.05.200
Notes:
- When electric energy is switched off for 1 minute synchronization of the base unit with the remote sensor and weather forecast data are stored In 1 minute the unit switches off completely Further you will have to synchronize operation of the base unit and the remote sensor again enter the data which are necessary for weather forecast.
• Each time after batteries changing in the remote sensor you will have to synchronize operation of the base unit and the remote sensor again.
• USB jack should not be used as an energy source or charging device for a USB-device different from a USB flash drive otherwise photo frame can be broken.
• If the base unit does not receive signal from the remote sensor for a long time check the batteries in the remote sensor replace them if necessary and repeat synchronization.
Place the remote sensor within the radius of effective data transfer as close as possible to the base unit Locate the base unit and the remote sensor in places with minimal interferences for better data transfer.
Take into account that the radius of data transfer of the remote sensor depends on the material of partitions of the room and their number Try several location variants of the remote sensor and the base unit Place the remote sensor in such a way that direct sunlight rain or snow does not get on it Home devices (doorbell alarm system etc) can interfere when the base unit receives data signal from the remote sensor It is normal and does not influence general operation Transfer and receipt of data signal will resume after interferences are removed
• When the remote control operation is unstable reduce distance between the remote control and the base unit Check the battery in the remote control and replace it if necessary
ENGLISH
6406_IM.indd 9
6406_IM.indd 9
12.03.2010 10:19:42
12.03.2010 10:19:42
Инструкция по эксплуатации Vitek VT-6406 — страница 9
Формат: Руководство
Страниц: 44
Категория: Фоторамки
Добавил: OLD
Инструкция для Инструкция по эксплуатации Vitek VT-6406 на русском языке. Документ можно использовать для ознакомления с информацией, относящейся к данной модели.
Инструкция представлена в формате PDF, просмотр, скачивание на компьютер, смартфон бесплатно. Возможность печати зависит от используемой программы и настроек устройства. Содержание, структура и объём документа могут различаться в зависимости от модели, версии и редакции руководства. Перед использованием рекомендуется убедиться, что инструкция соответствует вашей модели.