Инструкция по эксплуатации Vitek VT-6406 — страница 5

ENGLISH

4 Do not apply hard efforts to the units do not subjects the units to strikes (dust and moisture are also contraindicated

) as it can lead to failures and correspondingly to the reduction of life time damages of the batteries and to the deformation of the body details.

5 Do not dismantle the unit; it will lead to the ending of guarantee There are no details demanding attention of the user inside it 6 Use only new and specified in the manual batteries 7 Use the net adapter supplied

Connecting the net adapter to the base unit/placing batteries into the remote control and remote sensor:

Connecting the net adapter to the base unit 1 Make sure that the adapter voltage corresponds to the voltage in the mains 2

Using the external power supply jack connect the net adapter to the base unit supplied (5.0

V DC).

Placing batteries in the remote sensor 1 Unscrew the screws on the battery compartment lid. 2 Insert 2 batteries of AAA type following the polarity. 3 Close the battery compartment lid and tighten up the screws.

Placing batteries in the remote control

The remote control is supplied with the batteries CR 2025 inserted To activate the remote control pull out the insulating insert To replace the battery follow the instructions on the rear panel Follow the polarity when replacing the batteries.

Note: While long operation of the sensor in the conditions of extreme temperatures the voltage of its batteries can be lowered the operation radius of the remote sensor will be reduced.

Synchronization of operation of the basic unit and the remote sensor As soon as the power adapter is connected to the base unit it will start signal searching from the remote sensor during 4 minutes Before it you should open the battery compartment lid; select the data transfer channel insert batteries in the remote sensor After the batteries in the remote sensor are inserted it will start transfer of data which will appear on the display of the base unit During signal searching by the base unit press the TX button inside the battery compartment of the remote sensor for quicker data transfer After the data from the remote sensor are received they will appear on the display of the base unit To find channels from the remote sensor you can do the following procedure Enter the main menu by pressing the 9 Exit button of the base unit or the 7 MENU button on the remote control Use the ►/◄ buttons to select the Settings mode Press ENTER to confirm the mode Use the ▼ button to select the Receipt from external sensor item Use the ►/◄ buttons to select Search press Enter to confirm the parameters The base 6406_IM.indd 5

6406_IM.indd 5

12.03.2010 10:19:41

12.03.2010 10:19:41