Инструкция по эксплуатации Vitek VT-3965 R — страница 6

ENGLISH

37 Additional battery compartment lid (reserve supply for memory support)

38 Remote control SENSOR

Remote control (Pic 2)
STANDBY button

During operation press the STANDBY button The cassette recorder will switch to the standby mode The STANDBY indication will light up.

To return to normal playback press the STANDBY button once again.

2 FUNC button 3 BAND button REPEAT/MONO ST button 5 TIMER/SLEEP button 6 SKIP TUNING  button 7 PLAY/PAUSE button 8 STOP button 9 MUTE button a Press the button to mute sound. b Press the button again to cancel the mute mode.

0 RANDOM button SKIP TUNING  button

2 VOLUME

button

3 VOLUME

button

IR emitter 5 Battery compartment lid

POWER CONNECTION Line supply Before connecting the appliance make sure that your home electricity supply corresponds to the voltage specified on the appliance. To connect the appliance insert one end of the power cord in the jack (35 pic ) and the other one – in the socket The STANDBY indication will light up.

2 To switch on the appliance press the

POWER button.

Note: Static electricity can lead to interferences in the operation of the appliance In this case disconnect the appliance and then connect again If the problem does not disappear apply to the service center.

Battery supply Disconnect the cassette recorder. 2 Open the main battery compartment lid (36 pic ) on the rear of the appliance by pressing two catches following the arrow.

3 Open the additional battery compartment lid (37 pic.) Insert 3 UM-3/AA batteries (not supplied) in the battery compartment to support memory of the appliance Close the battery compartment lid (37 pic ). Insert 8 UM-/D batteries (not supplied) in the main battery compartment.

Close the battery compartment lid (36 pic ).

USING THE REMOTE CONTROL Insert 2 UM-/АAA batteries (not supplied) in the battery compartment of the remote control When using the remote control direct it to infrared SENSOR on the cassette recorder Effective distance of the remote control is about 5 meters if it decreases very much check the batteries and replace them if necessary

Functions of the remote control buttons are similar to those on the cassette recorder Some buttons perform two functions depending on the mode selected: disc playback mode or radio mode Do not expose the remote control to high temperature and direct sunlight; it can influence the operation of the appliance.

Attention!
Battery leakage can lead to injuries and damages of the appliance To avoid damages of batteries follow the instructions below:
Place the batteries properly following the polarity marked inside the appliance.

Do not use old and new batteries or batteries of different types together.

Take the batteries out if you are not going to use the appliance for a long time.

TIME SETTING You can set time when the cassette recorder is in the standby mode. Press the MEMORY/CLK-ADJ button once

Time indication will start flashing on the LCD display Use the SKIP TUNING  or 
button to adjust hours 2 Press the MEMORY/CLK-ADJ button once 3965IM.indd 6

07.07.2008 15:36:59