Инструкция по эксплуатации Vitek VT-3950 GY — страница 5

ENGLISH

28 The NEXT track button/fast forward /
29 The STOP/SD button 0 The REPEAT/RANDOM button Volume control (is inactive in the radio mode)

Before operating Unpack the unit Press the CLOSE/OPEN button and remove the protective insert before operating the unit.

POWER CONNECTION Line supply Before connecting the unit make sure that your home electricity supply corresponds to the voltage specified on the unit. To connect the unit insert the plug of the power cord in the corresponding jack (2) Set the switch () in the desired operating mode Note: Static electricity can lead to interferences in the operation of the unit In this case disconnect the unit and then connect it again If the problem does not disappear apply to the service center. 2 To switch off the unit disconnect the power cord from the power supply

Battery supply

Disconnect the CD/MP player from the power supply.

2 Open the main battery compartment lid (20) on the rear of the unit by pressing the catches following the arrow.

Insert 8 UM-2/R C batteries (not supplied) in the battery compartment following the polarity

Close the battery compartment lid (20).

USING THE REMOTE CONTROL

Insert 2 АAA batteries (not supplied) in the battery compartment of the remote control When using the remote control direct it to infrared SENSOR on the CD/MP player The effective distance of the remote control operation is about 5 meters in case of reduction of operating distance check the batteries and replace them if necessary.

The functions of the buttons on the remote control are the same as those of the buttons on the CD/MP player Do not expose the remote control to high temperature and direct sunlight; it can negatively influence the operation of the unit.

Attention!
Battery leakage can lead to injuries and damages of the unit To avoid damages of batteries follow the instructions below:
Place the batteries properly following the polarity marked inside the unit.

Do not use old and new batteries or batteries of different types together.

Take the batteries out if you are not going to use the unit for a long time.

BASIC FUNCTIONS Select operating mode using the switch ():

MP/CD RADIO OFF.

2 Use the volume knob to set the desired volume level (2).

After using the unit set the switch to OFF position.

Attention! In order to save energy always set the operating mode switch to OFF position when you do not use the unit.

Radio stations reception Set the operating mode switch to RADIO position 2 Select the desired range: FM AM or FM ST

(FM stereo) by setting the range switch to the corresponding position.

While tuning to the station transferring stereo signal the FM ST indication will light up.

Rotate the TUNING knob to select the desired radio station

For better reception in FM band extend the antenna completely For reception in AM band the CD/MP player has a built-in antenna for better reception in AM band try several variants of the CD/MP player location.

5 After you finish listening to the radio set the operating mode switch to OFF position or select another operating mode.

Playback of CD/MP3 discs

Your CD/MP player can playback the following disc types: Audio CD MP CD-R CD-RW This appliance does not play back PC discs СDi VCD DVD.

Note: Always close the discs slot lid to prevent it from dust Always extract the disc from the slot if it is not being played back Note: This unit can playback most of the discs 3950IM.indd 5

19.05.2008 14:58:32