Инструкция по эксплуатации Vitek VT-3543 — страница 6

ENGLISH

ALARM 1 setting In the ALARM 1 Display,

Press MODE for about seconds: the hour digits are blinking and can be set by pressing UP or

DOWN key.

Press MODE again: the minute digits are blinking and can be set by pressing UP or DOWN key.

Press MODE again the Alarm time is set and icon will turn on.

ALARM 2 setting In the ALARM Display,

Press MODE for about seconds: the hour digits are blinking and can set by pressing UP or

DOWN key.

Press MODE again: the minute digits are blinking and can be set by pressing UP or DOWN key.

Press MODE again the Alarm time is set and icon will turn on.

USING THE ALARM AND SNOOZE FOR DAILY ALARM 1 or ALARM 2 • Press the MODE button to turn the alarm 1 on or the alarm 1 off the alarm on or the alarm off.

• When the current time reaches the alarm time that is enabled the corresponding alarm is activated.

• Press the MODE button when the alarm is activated will stop the alarm for 4 hours.

• When the alarm is activated press the SNOOZE/LIGHT button and the alarm stops but sounds again after the snooze period (4 minutes snooze period is pre-programmed).

• The repeat alarm indicator will flash.

- The alarm will stop after 4 minutes if the MODE button or SNOOZE/LIGHT button is not pressed.

TO LIGHT THE CLOCK Press the SNOOZE/LIGHT button to light up the clock for seconds.

LOW BATTERY LEVEL DETECTION

Should the battery capacity drop to a level that is not sufficient to operate the clock the low battery indicator will light up The battery should be replaced as soon as possible

Specifications subject to change without prior notice.

3543IM_new.indd 6

15.07.2008 17:21:22