Инструкция по эксплуатации Vitek VT-3514 RU — страница 4

ENGLISH

6 AL ON/OFF 2 button (of the second alarm)

7 VOLUME control 8 TUNING knob 9 Display 10 Speaker 11 BAND button ( FM/АМ)
12 Radio ON/OFF button 13 SNOOZE/SLEEP/NAP button 14 180° FLIP button 15 PROJECTION ON/OFF button 16 ALARM ( Buzz/Radio ) switch 17 Projection 18 FOCUS control 19 AUX IN jack 20 RESET button 21 DIMMER (High/Low/Auto off) switch 22 Power cord 23 FM-antenna cord 24 Battery compartment lid

OPERATING INSTRUCTIONS Inserting batteries • Open the battery compartment lid and insert a 3V CR2032 battery (not supplied) following the polarity.

• Close the battery compartment lid.

Attention! Battery leakage can lead to injuries or damages of the unit In order to avoid damaging of the unit follow the following instructions:
insert the battery properly;
remove the battery if you are not planning to use the unit for a long time;

do not recharge do not dismantle and do not expose the battery to high temperatures;

replace the battery in time.

Note:
The unit is intended for operation from the mains battery operation is a reserve option Batteries help to store the settings of the current time and of the alarm in case of power failure or absence of power With the preset alarm actuation time in case of power failure when the preset time is reached you will hear a sound signal (even if radio is selected as alarm signal) that will be switched off automatically in 30 seconds To switch off the alarm press the ON/OFF button Remove the battery if you are not planning to use the unit for a long time.

Connecting the unit Before connecting the unit make sure that the electricity supply in your home sockets corresponds to the voltage specified on the housing of the unit Insert the plug into the socket and press the RESET button all indicator segments will be displayed (during 2 seconds) then the unit will switch to the current time display mode (normal mode).

Setting the current time In the current time mode press and hold the MODE button for more than 2 seconds to enter the current time and date setting mode Digits of the year will start flashing on the display Use the buttons to set the year Press the MODE button Digits of the month will start flashing on the display Use the buttons to set the month Press the MODE button Digits of the day will start flashing on the display Use the
buttons to set the day Press the MODE button Format digits 24 hours or 12 hours will start flashing on the display Use the buttons to set the time format Press the MODE button Digits of the hour will start flashing on the display Use the buttons to set the hour Press the MODE button Digits of the minutes will start flashing on the display Use the buttons to set the minutes.

Note:
If during 30 seconds the buttons are not pressed the unit will switch back to the current time display mode.