Инструкция по эксплуатации Vitek VT-3509 — страница 3

ENGLISH

CLOCK RADIO WITH NIGHT LIGHT

LOCATION OF CONTROLS 1 ON/OFF/AUTO Function selector 2 Display 3 Battery compartment 4 Radio frequency scale 5 Radio frequency tuning knob 6 Band selector 7 VOLUME/BUZZER knob 8 SNOOZE button 9 SLEEP button 10 MINUTE setting button 11 CLOCK setting button 12 HOUR setting button 13 “On/Off” switch for lamp 14 ALARM button

POWER 1 Connect the power cord to the outlet

Make sure that the voltage indicated on the device matches the voltage in your home.

2 Place one 9 V battery (not included) into the battery compartment (3) The battery maintains the clock in case of power failure In such cases the display will not work but the time is being maintained After long use the battery can go bad and leak If you use the unit without a battery then you will be required to set the time as instructed in the “Time Setting” section each time the unit is disconnected from power.

TURNING ON THE LIGHTING

1 Connect the power cord to the outlet. 2 Lift the body of the clock up from the sides until it stops. 3 Tighten the central bolts holding the body to the lamp as shown in the diagram.

4 Set the lighting switch (13) to the ON position.

Note: Do not forget to set the lighting switch (13) to the OFF position before installing the lamp shade Make sure the light bulb has cooled before changing Remove the old light bulb and install a new one (25 Wt bulb).

SETTING THE CURRENT TIME Press and hold the TIME button (11) set the hours by pressing the HOUR (12) button and the minutes by pressing the MINUTE button (10) The current time will be shown on the display (2).

RADIO 1 Set the function selector (1) to the ON position.

2 Set the band selector (6) to the FM1 or

FM2 position.

3 Set the radio to the desired broadcasting station using the TUNING knob (5).

4 Adjust the volume using the VOLUME knob (7).

5 Extend the antenna wire fully in order to achieve the best FM reception.

WAKING UP TO MUSIC 1 Set the function selector (1) to the ON position.

2 Set the band selector (6) to the FM1 or

FM2 position.

3 Set the desired station using the TUN-

ING knob (5).

4 Set the desired volume (7). 5 Set the function selector (1) to the AUTO position.

6 Press and hold the ALARM button (14) set the hours (12) and minutes (10) using the appropriate buttons.

7 In order to verify that the correct time has been set press the ALARM button (14). The set time will be saved to the device’s memory and the radio will turn on every day at the same time.