Инструкция по эксплуатации Vitek VT-1913 — страница 4

0 STOP 1 LOW SPEED 2 MEDIUM SPEED 3 HIGHSPEED

To switch the fan on simply press one of the push buttons (1 2 or 3) To stop it press the 0 push button.

OSCILLATION Simply press down on the button located vertically at the rear of the motor To stop the oscil lation action pull the button back up to its initial position.

SETTING THE TILT ANGLE Slack off the knurled screw on the ball joint move the fan to the desired angle then tighten the knurled screw down again.

MAINTENANCE 1 Always unplug the fan before performing any maintenance work. 2 Carefully clean the fan prior to storing. 3 When storing the fan during the winter months be sure to keep it in a dry location protect ed from damp. 4 While using the fan be sure to keep it clean by periodically wiping it with a cloth soaked in soapy water. 5 Never use detergents or solvents. 6 Always follow the assembly procedure with care when re assembling the fan.

SPECIFICATION Power

50 W

Voltage 220 230 V ~ 50 Hz

Blade diameter

16” (40 cm.)

3 speed control

SERVICE LIFE OF THE FAN NOT LESS THAN 5 YEARS

ENGLISH

СХЕМА ВЕНТИЛЯТОРА

РУССКИЙ

1913.qxd 03.12.03 14:53 Page 8