Инструкция по эксплуатации Vitek VT-1804 G — страница 3

WARNING To reduce the risk of fire electric shock or injury:
1 Do not leave vacuum cleaner when plugged in Unplug from outlet when no use and before servicing.

2 To reduce the risk of electric shock do not use outdoors or on wet surfaces. 3 Do not allow to be used as a toy Close attention is necessary when used by near chil dren.

4 Use only as described in this manual Use only manufacture`s recommend attach ments.

5 Do not use with damaged cord or plug If vacuum cleaner is not working as it should has been dropped damaged left outdoors or dropped into water enter it to a service center.

6 Do not pull or carry on cord use cord as a handle close door on cord or pull cord around sharp edges or corners Do not run vacuum cleaner over cord Keep cord away from heated surfaces.

7 Do not unplug by pulling on cord To unplug grasp the plug not the cord. 8 Do not handle plug or vacuum cleaner with net hands. 9 Do not put any object into openings Do not use with any opening blocked Keep free of dust lint hair and anything that may reduce airflow.

10 Keep hair loose clothing fingers and all parts of body away from openings and mov ing parts.

11 Use extra care when cleaning on stairs.

PRECAUTIONARY MEASURES If the opening that sucks in the air the suction pipe or the telescopic wand stick on pipe are blocked you should switch off the vacuum cleaner at once First clear the blocked substance before you attempt to start the vacuum cleaner again. 1 Do not operate the vacuum cleaner too close to heaters and like radiators cigarette butts etc.

2 Before you insert the plug into the wall contact make sure your hand is dry. 3 Before you start using the vacuum cleaner please remove large or sharp objects from the floor in order to prevent that the paper filter is damaged.

4 When you want to pull the plug from the wall contact please do this at the plug itself and not by maens of the electrical cable.

This vacuum cleaner is equipped with a plug and a cable which rolls up automatically If anything gets damaged both the plug and a cable must be repaired by a qualified repairman or electrician.

ASSEMBLING THE APPLIANCE

- Remove all the parts from the packaging and place them ready.

- Insert the rotating connector of the suction hose into the suction inlet until it clicks into place.

• The hose may be completely removed from the body of the cleaner by pressing the buttons on either side and pulling the connector up and out of the suction inlet.

• Join the two extension tubes together connect them to the handle of the suction hose and then attach the required nozzle the end of the tube.

ENGLISH

1804new.qxd 25.07.03 10:17 Page 6