Инструкция по эксплуатации Vitek VT-1371 — страница 8

РУССКИЙ

2 Remove the foil by releasing the foil locks from the foil holder as shown. 3 Carefully insert the new foil ensuring that the back of the foil face inwards Gently push the foil into position so that the foil locks into place. 4 Attach the foil holder.

REPLACING THE CUTTER 1 Remove the cutter. 2 Attach a new cutter.

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped The battery is to be disposed of safely The appliance must be disconnected from the supply when removing the bat tery In accordance with current recycling legislation do not dispose of the battery contained in this shaver with normal household waste When recharging can no longer be effected please dispose in the method advised by your local area council The following procedures should be followed for battery removal. 1 Set the slide switch to "1" and discharge the Ni Cd battery until this shaver stops operating.

Don't connect the charger.

2 Remove the shaver head and cutter. 3 Remove the front panel with a flat blade screwdriver With the switch '"0 CHARGE" insert the flat blade screwdriver into the upper end of the switch and lift up and remove the front panel. 4 Remove the two screws with a screwdriver and take out the head. 5 Remove the two screws from the bottom case with screwdriver and take out the inner unit. 6 Remove the Ni Cd battery and cut the lead wire at the jointed position to the terminals.

Pay attention not to short circuit the removed Ni Cd battery by contacting the positive and negative.

SPECIFICATIONS Power supply:

AC 230V ~ 50Hz

DC 2 pcs AA 1.5V rechargeable batteries

SERVICE LIFE OF THE RECHARGEABLE SHAVER NOT LESS THAN 3 YEARS

ENGLISH

УНИВЕРСАЛЬНАЯ БРИТВА

1371.qxd 04.09.03 9:59 Page 16