Инструкция по эксплуатации Vitek VT-1203 — страница 4

HINTS FOR IRONING 1 Sort out the articles to be ironed according to the type of fabric.

This will minimize the frequency of temperature adjustment for dif ferent garments.

2 Test ironing a small area on the backside or inside the garment if you are unsure about the type of fabric Start with a low tempera ture and increase gradually.

3 Wait for about three minutes before ironing heat sensitive fabrics.

Temperature adjustment needs certain time to reach the required level no matter it is higher or lower.

4 Delicate fabrics such as silk wool velour etc are best ironed with an ironing cloth to prevent shine marks.

5 You may need a few times of press to activate the spray burst and vertically burst function.

HOW TO FILL WATER 1 Disconnect the iron from mains supply outlet.

2 Move the Steam Control/Self Cleaning

Knob to position.

3 Fill water through the water inlet hole

(See figure 2)

4 Fill up to the 'Max' level marked on the side of water tank.

Note: For best result it is advisable to use demineralised water or dis tilled water Do not use chemically descaled water or any other liquids

FIRST TIME IRONING 1 Remove any protective films or stickers from the sole plate and the cabinet.

2 Unwind and straighten the power cord. 3 Fill the water tank with demineralised water or distilled water (See

How To Fill Water)

4 Connect the iron to a suitable mains supply outlet.

FIGURE 2

На ярлыке означает: изделие нельзя гладить!

(например эластик)

Примечание:

вид ткани синтетика синтетика ацетатволокно триацетат с люрексом полиамид (нейлон)

полиэстер вискоза шелк шерсть шерсть хлопок хлопок лен лен синтетика акрил полипропилен полиэтан волокно позиция терморегулятора ярлык шелк

ENGLISH

РУССКИЙ

1203.qxd 03.07.03 16:47 Page 8