Инструкция по эксплуатации Vitek VT-1122 — страница 3

! INSTRUCTION FOR USE OF THIS APPLIANCE

• Before using for the first time boil the kettle twice with clear water to make sure that it is completely clean Pour away all the boiled water and refill.

• Kettle can be filled either through the spout or open the lid Then fill water.

- Water level can be estimated through the window gauges at both sides on body.

• After filling your kettle with water place the kettle to the power base unit ensure the kettle completely sits on the connector Plug in and switch on the wall socket Switch on the kettle by pressing down the switch button.

• Do not overfill the kettle over the Max level However the minimum amount of water should reach the Min marking.

• When the water boils kettle will be automatically switch off

- To re boil the water switch on again by just pressing down the switch button once again If the kettle has just switch off automatically waiting for a minute before switching it.

• If the kettle do not fill with enough water or it is empty; switch on the kettle will cause the safety cutout switch off the power automatically If this happens set the switch level to OFF position and wait for a few minutes for the appli ance to cool down then refill with enough water and switch on as normal.

• Before removes the kettle from power stand ensure that the kettle is switched off.

• Power cord could be stand into the power base by just push the cord inside the base.

! FILTER

• If appliance installed with the filter always fill the appliance through the spout as this will help to restrict any major impurities & lime scale.

• To remove the filter open the lid and empty the appliance Push the filter outward the tab.

• Re install the filter slide it into the tag and press down it will snap on the tag firmly Ensure the filter is properly fit into the spout location.

ENGLISH

1122.qxd 30.04.03 13:48 Page 6